Jump to content
SAU Community

Recommended Posts

After over a million votes were cast, Ferrari have revealed their 2014 car will be called the F14 T.

http://www.planetf1.com/driver/18227/9131012/New-Ferrari-called-the-F14-T

And the lotus' proboscis are not equal length either!, with the left one about 5cm longer.

1390581202.jpg

The rules mandating a single nose tip, to be mounted far lower than previously and with a minimum cross section, were introduced for safety reasons.

The other cars that have so far been revealed have featured the 'anteater' nose, which forms the nose tip with a finger-like extension.

Lotus's twin tusk arrangement eschews this philosophy and stretches the wording of the rules to the limit.

In order to meet the single lower nose tip regulation, the two tusks are of unequal length, so the longer one forms the mandatory nose tip, while the other is short enough to avoid being considered part of the nose tip by the regulations.

This leaves each tusk to act as a crash structure, the front wing mounting pylon and then, as they slim narrow the rear of the car, also become turning vanes.

This means the unavoidable obstruction of the mandatory nose tip is made into a multi-purpose device.

The design may present slightly more total cross sectional area to the airflow, but places the obstruction in the most beneficial location.

http://www.autosport.com/news/report.php/id/112265

............... :ermm:

you guys should be happy, Lotus didn't make the penis nose you were so woried about!

McLaren are so broke without a naming sponsor they got Mercedes to throw in a few cans of paint with their engine deal. Car looks pretty good I think.

67839_570117296398695_176835976_n.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
×
×
  • Create New...