Jump to content
SAU Community

Recommended Posts

After over a million votes were cast, Ferrari have revealed their 2014 car will be called the F14 T.

http://www.planetf1.com/driver/18227/9131012/New-Ferrari-called-the-F14-T

And the lotus' proboscis are not equal length either!, with the left one about 5cm longer.

1390581202.jpg

The rules mandating a single nose tip, to be mounted far lower than previously and with a minimum cross section, were introduced for safety reasons.

The other cars that have so far been revealed have featured the 'anteater' nose, which forms the nose tip with a finger-like extension.

Lotus's twin tusk arrangement eschews this philosophy and stretches the wording of the rules to the limit.

In order to meet the single lower nose tip regulation, the two tusks are of unequal length, so the longer one forms the mandatory nose tip, while the other is short enough to avoid being considered part of the nose tip by the regulations.

This leaves each tusk to act as a crash structure, the front wing mounting pylon and then, as they slim narrow the rear of the car, also become turning vanes.

This means the unavoidable obstruction of the mandatory nose tip is made into a multi-purpose device.

The design may present slightly more total cross sectional area to the airflow, but places the obstruction in the most beneficial location.

http://www.autosport.com/news/report.php/id/112265

............... :ermm:

you guys should be happy, Lotus didn't make the penis nose you were so woried about!

McLaren are so broke without a naming sponsor they got Mercedes to throw in a few cans of paint with their engine deal. Car looks pretty good I think.

67839_570117296398695_176835976_n.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah in that case, pulling the dent out. Event a very slight dent can create a lot of work filler-wise and there is a strong chance the panel won't be the factory shape when you are done (as the dent will result in a new high point created somewhere, then everything is brought up to that new high point... but the panel shouldn't be that high if that makes sense).  So you've filled and primed the panel and it is flat, why would you go back and remove the primer and add more filler? 
    • Something else I have been faffing with while the car was off the road is making the AC work. Assuming the car isn't at a thermal limit the idea of having AC while waiting in line to go on track sounds delightful. I have actually been lugging around the weight of the entire system since 2018 when the RB25NEO went in without it working at all.  The main reason was in the first few events before I got around to re-gassing it the rubber hose that runs under the manifold had the factory heat wrap/sleeve fail resulting in this: ~2 years ago I purchased a complete used R32 AC line set but when I finally went to install it the line i needed was different where the expansion section is I found a local place that was able to replace the rubber section and re-crimp. They also added some modern heat sleeve to the hose Tight fit but fingers crossed this is the last physical piece of the puzzle needed
    • the top black section is bonded to the silver section with some form of rubber. I assume to isolated NVH from the box
    • Plan B? Get someone to machine up a metal bush/collar/whatever it needs to be to replace the rubber? I haven't had a close look at that part recently to have a proper feel for whether that's possible. But it might be easy.
    • I do not want to install a short shifter and the only other stock throw shifter I have seen is the Nismo "Rigid shifter" for $290 So plan A is to fill it with sikaflex to stiffen it up and hope for the best
×
×
  • Create New...