Jump to content
SAU Community

Recommended Posts

R32 gtr - 89 - 120,000km - Gun metal grey - 8.5k ono Stolen and recovered. (missing vin plate and compliance plate)

I bought this 32 GTR at auction last week with the intention of fixing her up but I've quickly lost interest and lack the motivation or time for this project.

One of those impulse buys .Like when you buy a gum membership.. haha

Spent about 30 mins trying to start it via the hot wired mess it came in, ignition barell is smashed and wires have been cut in the engine bay.

Can't get it started at this stage,

I don't actually know much about the car. from what I can see the mods are

Aluminium radiator

Purple coil overs

Cam gears

Damaged parts

ignition barrel

wiring harness

windscreen

compliance plate & vin plate have been stolen.

interior is in average condition, exterior is in fair-good condition

Car sold as is, will supply receipt as proof of purchase from the auction house.

Mark - 0438 416 584

post-18827-0-97067000-1399293911_thumb.jpg

post-18827-0-14727100-1399293931_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/442743-r32-gtr-85k-vic/
Share on other sites

If u got it from pickles auction then it will be stuffed eg wire cut on per-purse and under the car the hoses and pipes will be damaged from fork lift this car is not worth what u put the price on it ill buy it for around 3k 5k bing max

Link to comment
https://www.sau.com.au/forums/topic/442743-r32-gtr-85k-vic/#findComment-7276381
Share on other sites

You went from 8.5k ono to 8.5k firm after telling us the wing got stolen?

Might go out and hit my car with a sledgehammer, increase its value a bit...

  • Like 5
Link to comment
https://www.sau.com.au/forums/topic/442743-r32-gtr-85k-vic/#findComment-7285064
Share on other sites

Haha. I was replying to the question of what other damage was caused.

New Windscreen installed

New locks and barrel installed

Rear wing replaced

Import approval papers on the way from dotars.

Price hike 9.5k

Link to comment
https://www.sau.com.au/forums/topic/442743-r32-gtr-85k-vic/#findComment-7286893
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...