Jump to content
SAU Community

Recommended Posts

hey there, have just got my s2 rb25det r32 running..
its pretty much standard apart from fmic, splitfire coilpaks, alloy rad, 3inch striaght pipe exhaust etc.
it idles perfectly... but when driving it splatters/coughs doesnt boost etc. you can drive without hitting turbo but with foot flat down or like 30% throttle plus it missfires splatters and all that like crazy making backfire noises and such. does it in every gear aswell. it idles perfect never dies when coming to a stop or anything. i recently changed rad, thermostat, exhaust pipe recently. all lines im pretty sure are plumbed in correctly. one thing i did do was move the cas when i took the timing cover off. could that be it? but yea it idles perfectly its just when trying to drive or accelerate at 2500revs plus the problems start. it revs fine when not in gear too.. another note the conversion was only just recently done maybe a couple months ago but was first driven today since installed. i only just started it yesterday. will try to play around with a few things tomorrow but yea im no mechanic so help would be good.. thanks for reading and any help will be much appreciated

Check for boost leaks.

Search how to pressure test.

What ecu?

It isn't likely to be caused by moving the cas, but you have to set the timing with a timing light.

Edited by Ben C34

Yea get a timing light and check timing due to you have moved cas and check AFM, get done contact cleaner and spray it inside AFM cleaning all the crap off, let it sit for abit allowing contact cleaner to fully dry up and re-install it and away u go, had that issue with my S1 25det r33

thankyou for the replies guys, yea have been told its mostlikely the afm so will clean as it as said above and go from there. ^ and then i will try sort the timing out. once again appreciate the help!!

  • 6 years later...
On 19/05/2014 at 1:25 PM, brandysnaps117 said:

thankyou for the replies guys, yea have been told its mostlikely the afm so will clean as it as said above and go from there. ^ and then i will try sort the timing out. once again appreciate the help!!

I take it that it was the AFM as this was last reply on thread?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
×
×
  • Create New...