Jump to content
SAU Community

Recommended Posts

At the risk of sounding like a idiot im having some issues. I have a r33 gtst. Ive just recently replaced the std fuel pump with a walbro255lph and since ive installed it the car has been running like a dog. Its been splattering and just generally running like a pig lol. So i really need some help would the best bet just put the std back in until i get a tune? Or is there something else i can do in the mean time to get it running half normal again

Link to comment
https://www.sau.com.au/forums/topic/448830-fuel-pump-issues/
Share on other sites

Unless your car was tuned to suit a half dead pump putting a walbro in won't make it run bad or need a tune..

Ideally you will have run a direct feed to the battery, but again, if not there won't necessarily make it run like crap.

Yeah its doing my head. So i guess eother put the half dead one in then when i get it tuned put the walbro back in or just dont drive it until i get it tuned lol

Edited by cav33r

So if the direct power souce doesnt work then i can rule out everything else and bascially conclude the pump was a dud

There is also the actual fitting of the pump - location in the cradle/tank, attachment and orientation of the pickup and filter and correct connection of the fuel lines.

Fuel lines have been put back to orignal positions so no real issue there. And it sits in the cardle basically the same as the standard one and put the cradle back in the housing in the tank. So basically exactly how the standard one was is how the walbro is. Ive just emailed the guys i bought it off to see if they will send me a replacment one under their warranty basically to see if it is the pump or somethin else.

And i used the orginal sock off the standard pump because i was looking at the tiny tiny sock they supplied with the pump and basically said yeah no lol. So i put the orignal longer sock back on it

Some workshops can run the new pump in vitro to check flow rate.

I once had a brand new but faulty 044 and the flow rate was barely over 20.

Had to replace it with another 044.

Yes, the faulty one was genuine from Just Jap; but alas, Bosch would not honour the warranty.

They did pull a swifty though. After testing in Melbourne they sent it back in the original box. But it didn't have the texta mark I placed on the faulty one. Caught the buggers out!

Hahaha shifty ones. Well ill see how i go. If i can handle this company to send me a replacement pump and i get it fitted and it still does the same then i have to look deeper into the issue but if it doesnt well it was obviously the pump then. So fingers crossed

Ive just been doing some more reading on what could possibly be causing this problem besides it being a dud pump, ive found that pump i have may not necessarily be a high pressure and if there is any more then 60psi of pump pressure running through it it could cause it to drop in power. I had a look at my fuel reg this morning while on idle and it was showing like 105 psi so obviously under load and boost the fuel pressure is sky rocketing. So my thoughts is if i drop the fuel pressure and get the combined fuel and boost psi under 60 should it then resolve the problem?

No way should you be running 105 psi base.

That's mental.

Like really mental.

You have problems. You can't just drop the pressure on the reg and expect the car to run correctly.

Edited by Ben C34

i know it is i haven had it tuned since ive gotten the car. Previous owner had it tuned to that . Ive just now realized how stupid high it is. I look at it this morning and got a little bit confused.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...