Jump to content
SAU Community

Rb25Det Not Boosting Well

rb25debt

By rb25debt,
in Engines & Forced Induction

 Share

Recommended Posts

rb25debt Contributor

rb25debt

Posted
Posted

Hi guys, i have a r32 with a rb25det neo in it from a rs4 Stagea. Car was originally auto but is now manual converted.

the problem i have is, it will boost up to around 8 psi and the gate opens. But it doesn't really feel like its boosting. Its also a bit hesitant.

It has a master power t04e, front mount, all the basic mods. Ive only recently got it and have just began tidying it up. I'm pretty sure it hasn't been tuned for the t04e so that could be the problem. But the thing is when it hits boost it almost feels like its letting all the boost out, sort of like a exhaust leak.

Im just learning things atm and trying not to use the turbo in the mean time.

Any ideas?

Thanks for any help guys

Link to comment
https://www.sau.com.au/forums/topic/449751-rb25det-not-boosting-well/
Share on other sites
GTSBoy Grand Master

GTSBoy

Posted
Posted

Nonononononojnononopnonononodondonondonooooooo

You can't try to boost up a Neo ECU past about 11 psi on a STANDARD turbo without causing it to clip the air-flow meter, hit the boost limit (there is a boost sensor connected to the crossover pipe) and various other shits and giggles.

If you try to boost it up on a BIG turbo, then expect the shits and giggles to start happening at lower boost. 8 psi would be about right.

The thing will make boost, but the ECU will overfuel and cut timing so badly that it will be slow slow slow. Push it further and they will actuall give you a very nasty hard cut.

If you keep driving it like this you will damage it. You have to either piss that shitful turbo off or do something about the ECU (and the AFM and the injectors and probably the fuel pump).

rb25debt Contributor

rb25debt

Posted
  • Author
Posted

Nonononononojnononopnonononodondonondonooooooo

You can't try to boost up a Neo ECU past about 11 psi on a STANDARD turbo without causing it to clip the air-flow meter, hit the boost limit (there is a boost sensor connected to the crossover pipe) and various other shits and giggles.

If you try to boost it up on a BIG turbo, then expect the shits and giggles to start happening at lower boost. 8 psi would be about right.

The thing will make boost, but the ECU will overfuel and cut timing so badly that it will be slow slow slow. Push it further and they will actuall give you a very nasty hard cut.

If you keep driving it like this you will damage it. You have to either piss that shitful turbo off or do something about the ECU (and the AFM and the injectors and probably the fuel pump).

Ok sweet as man, theres not much that can be done with a neo ecu aye. would my best option just be to put a standard 25det turbo on it? I don't want to make big power, i'd prefer it to be reliable and standard.

GTSBoy Grand Master

GTSBoy

Posted
Posted

Ok sweet as man, theres not much that can be done with a neo ecu aye. would my best option just be to put a standard 25det turbo on it? I don't want to make big power, i'd prefer it to be reliable and standard.

Yes, there is something you can do about the Neo's ECU. It is actually far better than an R33 ECU in that regard. You can get it Nistuned (which is a tunable daughterboard which gets installed inside the ECU) for, well, about $600 I guess. If it then needs to be tuned you pay for dyno tuning too.

You'd actually be well advised NOT to put a std 25 turbo on there. They are all getting a bit old. They are ceramic. They can and will die at random.

I suggest that you do some searching on here amongst the millions and millions of posts about what a good turbo option would be for you. I'm not going to type it all out again.

rb25debt Contributor

rb25debt

Posted
  • Author
Posted

Yes, there is something you can do about the Neo's ECU. It is actually far better than an R33 ECU in that regard. You can get it Nistuned (which is a tunable daughterboard which gets installed inside the ECU) for, well, about $600 I guess. If it then needs to be tuned you pay for dyno tuning too.

You'd actually be well advised NOT to put a std 25 turbo on there. They are all getting a bit old. They are ceramic. They can and will die at random.

I suggest that you do some searching on here amongst the millions and millions of posts about what a good turbo option would be for you. I'm not going to type it all out again.

Cool, cheers for the help man, i appreciate it. I'll look into the Nistune daughterboard as it sounds like the best option for me. I also noticed there was a hole in the hose that comes of the j pipe. Would you know what that part is called as i need a replacement one.

rb25debt Contributor

rb25debt

Posted
  • Author
Posted

If you're in Sydney and want a road tune for your basic mods for your Nistune I have both software, hardware and a portable wideband.

Cheers bro i live in New zealand though, i'm pretty keen on getting a Nistune

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • BaronOBeefdip
      Baron's R34 GT-R build thread - car in Japan for 5 years -_-

      By BaronOBeefdip · Posted

      Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to it's full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so damn hot in there, that made it all the more easy to remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. I was standing there looking at the car and said 'f**k it'. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Bwagz
      Engine model

      By Bwagz · Posted

      Thanks for that, hadn’t used my brain enough to think about that. 
    • MBS206
      R33 GTR running -9 with no tune

      By MBS206 · Posted

      Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Piggaz
      Garrett G Series

      By Piggaz · Posted

      Any G40/1000 or G40/1250 results out there?  
    • joshuaho96
      R33 GTR running -9 with no tune

      By joshuaho96 · Posted

      You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...