Jump to content
SAU Community

Recommended Posts

Yes, of course it is. Go and try to get something fixed and see how you go.

They will always say it was a pre-existing condition (how are you going to prove otherwise), or you caused the defect due to abuse (again how are you going to prove otherwise). There are fewer more unscrupulous people in the world than used car dealers. Ask anyone that has ever tried to claim anything on a 2nd hand car warranty. The devil is in the fine print.

yeah. unless the engine falls out as you are driving the car away from the dealer when you bought it.. you are most likely out of luck. Most 'used car warranties', aren't worth the paper they are written on.

I did get a new muffler under used car warranty once, but only because it was the service manager's last day before starting a job with another company, so he didn't care!

According to most used car dealers, pretty much everything is wear and tear/consumables and therefore outside the scope of a warranty.

In NZ we're covered by the Consumer Guarantees Act that states a good must be in serviceable condition for a length of time that would be reasonably expected of that good, so if it fails within that time it's up to the retailer to repair/replace/refund the item. Because of this extended warranties are largely pointless.

Of course, "reasonable" is a term that's subjective, and that's where issues come in. You might expect your newly acquired car to go for 24 months without a significant fault but the dealer might think 3 months is long enough. There's bound to be a simliar law in Australia.

lol "may be useless" - I love your glass half full attitude.

You have been had by one of the best car dealer scams that has ever been conceived.

Don't worry about it. If worst comes to worst you take your car to try and claim on any 'warranty'. If/when they reject is you get heavy with them and point out how interested the ACCC/Current Affair and the like are interested in stories like this. If they cave you get your car fixed - if they don't you pony up the cash and fix it yourself. That is life.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...