Jump to content
SAU Community

Recommended Posts

Found the guy that smashed the r33 on closed group on Facebook
56bb3f6407a821c35e83461ef9e4df62.jpg

He paid $7k for it wants 5. Now the car is pretty much right off but some of the comments say its tuned at 300hp
I rekon he will be parting it out as people suggest that he could get 3k in parts.

I doubt some silly person will pay $5K as he wants.

5316c8fdae3d57b79a4e1277e08564d2.jpg

Morning sesh with this human [emoji1345][emoji19][emoji1320] Happy Weekend y'all


Manne I hear you ! Give me a shout if you need some extra work - I need 3 cars to be detailed clean [emoji22] my Car detail guy kinda bit busy since he's got the new shop and Miles away :(

  • Like 2

The Honda my daily run around , the WRX hubby's car and of course the R35 [emoji28] don't be nervous it's only a car. Desperately need a clean. Selling the Honda to dave's old folk as I'm getting new one.
3 motorbikes if you have time ?

Im Working Monday, Working Tuesday, and Work Thursday Morning until 3pm.
Talk about bad timing.

Wednesday and Friday are my days off this week. Will check next week when I get to work

Edited by Manne
  • Like 3



  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...