Jump to content
SAU Community

Recommended Posts

On 02/05/2018 at 10:51 AM, ElleAli76 said:

Hello boys ! Back in Perth yesterday , Saudi was good , just a bit hot from my liking emoji28.png anyway need help - anyone knows any contact or trust shipping company in Melbourne ?

Welcome bk!

  • Like 1
29 minutes ago, t_revz said:

 


Boo

Ghey

 

I know, right?

on the upside, dude fitting the tyres complimented me on the complete lack of chicken strips on the old rear knobbly.

REALLY need to find a bloke that does epic fabrication on fuel tanks too, if anyone has any suggestions.

Hi,

Wheels arrived from Japan. 18x9.5 +15 old skool

The SSR Type C were released in a gunmetal colour (and a bronze and gold). really wanted the colour code....

Contacted SSR via emails and facebook message to their 3 sites. most wont reply. and one in Aus says they wont give out the information.

Might just have to go some custom gunmetal. . . Bagh frustrating.

ranged from $100 to $300 aud per wheel for the work =/

Good reviews on google of "alliance rim repair".

20180427_191639.jpg

  • Like 1



  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...