Jump to content
SAU Community

370gt Coupe Questions

Nod089
 Share

Recommended Posts

Nod089 Enthusiast

Nod089

Posted
Posted

Hi guys,

These are probably questions that have been answered before, but I can't find them.

I'm looking at importing a 370GT SP and was wondering:

1. How easy is it to service and source parts for? Costly?

2. Is there an anchor point for a baby seat? NOT keen on a sedan.

Thanks so much for your help!

Nod

Link to comment
https://www.sau.com.au/forums/topic/457281-370gt-coupe-questions/
Share on other sites
Bliksem Veteran

Bliksem

Posted
Posted

1. Not too hard. For what its worth the 370GT is the same as the infiniti G37S which is sold in Australia and the USA. The 370GT also shares the same engine and driveline as the 370Z so another plus there. The in car entertainment is the biggest difference as its a japanese system (note: this can be changed to english for approx $2.5k) so if this ever has issues it would probably mean sourcing spares from an importer at this point in time.

2. Yes although I dont know what sort as I havent had to worry about a baby seat yet. I have seen some posts around about the anchor point needing am adaptor?? Someone else should be able to answer this with more info.

  • Like 1
sonicii Veteran

sonicii

Posted
Posted

I don't think it would get through compliance without baby seat anchor points. The V35 sedan needed a centre rear anchor point installed at compliance.

I can't imagine it will be easy to get a baby in and out of the back of a coupe though, but if it is important enough to have a coupe, I guess you will cope.

Nod089 Enthusiast

Nod089

Posted
  • Author
Posted

I don't think it would get through compliance without baby seat anchor points. The V35 sedan needed a centre rear anchor point installed at compliance.

I can't imagine it will be easy to get a baby in and out of the back of a coupe though, but if it is important enough to have a coupe, I guess you will cope.

Thanks guys :)

The GT will be my work car (the 2nd car). I just wanted to make sure for the odd occasion that I'll need to pick Little Miss up from pre school.

Nod089 Enthusiast

Nod089

Posted
  • Author
Posted

1. Not too hard. For what its worth the 370GT is the same as the infiniti G37S which is sold in Australia and the USA. The 370GT also shares the same engine and driveline as the 370Z so another plus there. The in car entertainment is the biggest difference as its a japanese system (note: this can be changed to english for approx $2.5k) so if this ever has issues it would probably mean sourcing spares from an importer at this point in time.

2. Yes although I dont know what sort as I havent had to worry about a baby seat yet. I have seen some posts around about the anchor point needing am adaptor?? Someone else should be able to answer this with more info.

Thanks for your help!!

Any idea of suppliers in Sydney and surrounds who do the conversion? Will the conversion mean GPS, radio and cameras will all still be functional with the 2.5K price tag?

AikenLugonn Enthusiast

AikenLugonn

Posted
Posted

re 2. No adaptations required for baby seats, and it has two anchor points. I have even had two set up in mine for the occasional family drive (both forward-facing seats). A slight pain being a two-door, but overall no drama.

Nod089 Enthusiast

Nod089

Posted
  • Author
Posted

re 2. No adaptations required for baby seats, and it has two anchor points. I have even had two set up in mine for the occasional family drive (both forward-facing seats). A slight pain being a two-door, but overall no drama.

That's good to hear, cheers!

Nod089 Enthusiast

Nod089

Posted
  • Author
Posted

As long as the kidlet is sitting in a seat, they are fine. My daughter is now 5 and she has been in the back of my 370GT Coupe for over 2 years. Make it work!!!

Certainly keen to make it work, it's just so much more appealing to me @ 25 y/o. If I were mid 30's I'd probably go the sedan but I'll cross that bridge when I come to it :)

The Max Mentor

The Max

Posted
Posted

Certainly keen to make it work, it's just so much more appealing to me @ 25 y/o. If I were mid 30's I'd probably go the sedan but I'll cross that bridge when I come to it :)

Hah! I went the reverse - from a '92 J30 Maxima for nearly 17 years until the V36 coupe took its place when I was 35. :P

  • Like 1
sonicii Veteran

sonicii

Posted
Posted (edited)

Hah! I went the reverse - from a '92 J30 Maxima for nearly 17 years until the V36 coupe took its place when I was 35. :P

:) I had a '93 J30 for 13 years.. but only changed to a V35 6MT sedan at 37 :).. now the kids are old enough to get themselves in and out of the car, I probably would go with a coupe if I could get a reasonable figure for my sedan.

As for the OPs choice.. go for the coupe.. one day practicality will take a higher priority like it did for me.. until then.. enjoy it!

Edited by sonicii
  • Like 1
Nod089 Enthusiast

Nod089

Posted
  • Author
Posted

:) I had a '93 J30 for 13 years.. but only changed to a V35 6MT sedan at 37 :).. now the kids are old enough to get themselves in and out of the car, I probably would go with a coupe if I could get a reasonable figure for my sedan.

As for the OPs choice.. go for the coupe.. one day practicality will take a higher priority like it did for me.. until then.. enjoy it!

My thoughts exactly :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...