Jump to content
SAU Community

Recommended Posts

Hello everyone.

Unfortunately I have to give up this project as it's become too costly to repair.

The following items are for sale.

For sale:

Completey rebuilt rb26 head

New shims

K line valve guides

Rocker covers

Timing cover

All cold side and sensors $2k

6 boost rb2630 r32 T4 manifold with genuine Tial 60mm gate $1400

Spool RB30 H beam rods complete set $500

Rb2530 20thou CP flat top pistons x5 $500

Rb20 Metal Jacket 1500hp balancer $500

Arp rb25 mains with all washers and bolts $200

R32 Gtr gearbox, rebuilt $700.

Rb30 awd block (Machined to accept awd adaptor plate), comes with oil restrictiors, grub screwed crank with crank collar, needs rebore to 87mm, bigger skyline rb30 block, also already tapped for twin cam head conversion for tensioner $400

Rb30 awd adaptor plate $350

Comes with pickup and bolts.

Rb20 alternator $50

Rb starter motor, rebuilt $50

Braided, Teflon and heat covered turbo oil and water lines $150

R32 front brake callipers with pads, new front and rear $100

R33 slotted brake rotors, not used, can get machined Rda brand, $100 for the pair

R32/33 boss kit and wheel, just needs screws and horn piece $50

Rb25de head with intake, needs machine from washer hitting quench area, fixable, talk to Mick at Probuilt, come with exhaust manifold and head studs (arp), has 110lb upgraded springs $600.

R32 ac compreasor $30

Have NO idea how to attach pics via Iphone. Can mms to you no worries.

Link to comment
https://www.sau.com.au/forums/topic/463547-rb2526-30-gear-for-sale/
Share on other sites

Custom intake on the rb25de head too, also off r32 rb25de.

If someone has an r33 gtst manual too, and they needstuff for their gtr, I'll swap the whole lot.

Must be in reasonable condition.

Edited by Gts4RB30

Have 3 rb30 blocks too, all have turbo drain and feed. All in different state.

One bottom end virgin short block

One rb30 awd modified with crank and collar and grub screwed crank ready for twin cam head conversion as stated upper.

One rb 30 awd modified block and girdle ready for twin cam head conversion.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
×
×
  • Create New...