Jump to content
SAU Community

Recommended Posts

My first run not modded was around 15 something

Got it down to 14.98 in the same session

The time I went with exhaust, pod filter and stock boost did high 14's couple of low 15's

Last time best was 14.18 with bald tyres, it will be in the 13's next time :P

If a stock skyline can't break 15.5 it would be because of the driver .... not the car

Someone claims to know "lots" of 32/33's that cant break 15.5 down the quarter.... wtf ..??

:P

Hrm.. That's 1, 2, 3 .. Three people who all did 15's in a skyline..

He's taking a dig at me because I said yesterday that I knew "lots" of people who had done 15's in a skyline. Maybe I exagerated a bit, but theres three people on this forum who have just said they ran 15's stock.

haha not just wheelspin with the rockhard tyres... also got to give credit to grandma gear shift speed..and NFI what I'm doing :)

2.884 60ft actually.. :P even my 18.6s 1/4mile golf does faster 60ft than that :(

however at end of that night the time improved to 13.6@112mph :thankyou: (toilet break helps I guess :) )

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...