Jump to content
SAU Community

What is this swith for? ? 260rs

livewire

By livewire,
in Four Door Family & Wagoneers

 Share

Recommended Posts

livewire Experienced

livewire

Posted
Posted

Hey guys. I just purchased an autech 260rs and came across a little switch on the drivers side kick panel near accelerator pedal. It kinda looks factory as the 'off' writing isnt a sticker or painted on by hand. I innitially thought it may be a kill switch but after testing its not. Does anyone else have this switch or know what it could be?

Thanks

20160722_140857.jpg

Link to comment
https://www.sau.com.au/forums/topic/465935-what-is-this-swith-for-%3F-260rs/
Share on other sites
Cowboy1600 Grand Master

Cowboy1600

Posted
Posted

At a guess it's the 2wd switch.  Turn ignition on, flick it to OFF, start car, pump brake pedal 5 times.  Does 4wd light come on?

KiwiRS4T Grand Master

KiwiRS4T

Posted
Posted
3 hours ago, livewire said:

I'll give that a go when i get a chance. I didnt know you could actually have a 2wd switch fitted. 

Any ideas on diff lock switch?

There is no diff lock in the Atessa scheme of things. There is a switch which will give you a 50/50 fore and aft power split but that only operates at low speeds for e.g. getting you out of a muddy paddock or up a boat ramp. As soon as you hit 20 km/hr or so it reverts to the stock 95% rear until the rear wheels start to spin.

The 2wd switch (if that's what it is...its not a factory item someone had to install it to save you pulling the plug behind the driver's kick panel)  works as described by Aaron but it only works until you turn  the engine off and then you have to set it again. From the manual:

Locate the "air bleed" wire behind the drivers kick panel, it's a plug with a single wire either side (usually green socket, white plug).

Disconnect it.

Start car. As key comes back to the ON position, within 10 seconds, depress brake pedal 5 times, 4WD light will start flashing to indicate you are in 2WD mode.

To go back to 4WD mode, turn car off, reconnect plug and off you go.

 

 

TMLP Community Regular

TMLP

Posted
Posted

I have a 260RS THERE IS NO  diff lock button there are few things incorrect in that page of info Dont take it as gospel if yours doesn't match. 

I also have 2 switches over my door near my head I the roof liner. NO idea what they do either. 

Duncan Grand Master

Duncan

Posted
Posted

Yeah I guess the diff lock button must be a 260RS thing because all the other models have them; strange to exclude because I wasn't aware of any other difference in the ATTESSA system.

 

The only switches normally on the roof are sunroof or courtesy lights

KiwiRS4T Grand Master

KiwiRS4T

Posted
Posted

The article is wrong there is no diff lock in the RB world and hence no diff lock button. The idea probably comes from a misunderstanding of the function of the switch I described above which is common to all attessa equipped Stageas. The Attessa reservoir is not an exclusively  260RS feature it is a feature of all awd Stageas.

  • Like 1
Gezza1er Newbie

Gezza1er

Posted
Posted

HAHA my Autech is in this Article. Very 1st pic from Fuji. My S2 Autech also had a switch that looks like yours but near my rear fog light switch. looked to see what it did. was just connected to a earth so i pull that out. just thought i would add my 2 cents.

 

  • Like 1
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • perry_r33
      R34 GTR Vspec Garage Sale - All must go!

      By perry_r33 · Posted

      Pm sent 
    • Robot
      Skyline v36 350GT sedan hunting on idle

      By Robot · Posted

      Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...