Jump to content
SAU Community

Recommended Posts

Oil going missing = air/oil separator time?

I notice that when running the engine hard its now using some oil, but there's no smoke, and i cant see any oil leaks. I would have expected to see a little blue smoke if oil was getting consumed - can the engine be burning oil if there's no smoke? Should i get a catch can/air oil separator?

To see if its getting past the rings build up some speed and then lift off for a few seconds and then accelerate - a puff of smoke at this point suggests you are burning it

  • Like 1
17 hours ago, KiwiRS4T said:

To see if its getting past the rings build up some speed and then lift off for a few seconds and then accelerate - a puff of smoke at this point suggests you are burning it

I always thought this tested worn valve stem seals, i.e, engine under vacume, then WOT and if it puffs blue smoke, valve stem seals are on way out.

On 12/14/2016 at 6:29 PM, KiwiRS4T said:

To see if its getting past the rings build up some speed and then lift off for a few seconds and then accelerate - a puff of smoke at this point suggests you are burning it

Tried it - no smoke.

A previous engine of mine used a little oil but didn't produce any smoke at all. Leak down was in the high teens. If there's no oil in the pcv system just keep it topped up. Though a catch can or air oil separator is probably a good idea on any rb.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...