Jump to content
SAU Community

Recommended Posts

Hey fellas

i got an issue that just arised last week and it's driving me crazy !

car will cold start and idle fine, hot idle is fine but when I'm driving if I down shift and the rpm is over 2000rpm and then pop in neutral it will stay idling at 2000rpm

sometimes it might fall back down to 1000rpm after 5seconds or so but most of the time it will stay there until I pump the throttle then it will settle to 1000

if the car is idling and I pump the throttle again it will idle at 2000rpm until I give the throttle a quick jab the it will settle

 

im running a hypertune plenum and 90mm throttle body, gave the throttle body a clean afew days ago and did a tps reset still no change

also did a pressure test and seemed good

I noticed driveability issues around the 2000rpm like it surges too

i spoke to hypertune and they said to send them the throttle body to test (incase shaft seals are leaking, it's only 2 years old) and to rebuild if necessary 

 

if anyone has any other ideas I can try that would be great

 

thanks

 

 

 

 

 

 

Edited by SiR_RB

What are your plastic throttle spring retainers like? I had a similar issue and it turned out being the plastic retainers had perished and the springs were binding

edit: scratch that I've just read you are running a single throttle.

Edited by Sub Boy32
Was a Muppet and didn't read the OP

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
    • EMU Classic. For what I need it to do I see no reason to upgrade. Link and Haltech would both cost an extra chunk of money for a lot of unutilized features
×
×
  • Create New...