Jump to content
SAU Community

Recommended Posts

So first off, apologies. This looks like it's mainly a Nissan forum, but when I typed Car Audio Forum Aus, this as the only one to show up.

I have an 07 Camry Grande, which I tried to boost the stereo in. I have alpine type s speakers on order and have an alpine booster 445u from my other car. I tried to install the booster ready for the speakers, and as soon as I plugged back in the head unit there was a crackle and a big puff of smoke from the stereo (I hadn't even turned the car on). Ive followed every wiring diagram I could, and had pre-wired the booster with universal plugs (which worked fine on my car), and am stumped on what could've caused it. I think Camry's have a factory amp, so would that and the booster have fried the stereo? 

Like I said, I'm really stumped as to what could've caused it, but need to work it out so it doesn't fry the next one I try to install.

Link to comment
https://www.sau.com.au/forums/topic/480851-stereo-fried/
Share on other sites

It's basically an amp, but doesn't require the direct line from the battery. I think the advertised term is a power pack. I had it on my Commodore and it boosted the output of the head deck, and it just ran off the stereo loom. Once I upgraded stereos though, it wasn't needed.

I had another look today, pulled all the dash apart, glove box etc, and haven't found the factory amp others are claiming should be there, so no idea. I have removed the power pack/booster for the time being, but would like to reinstall when the speakers come, as the head unit isn't going to be strong enough to drive them. You have to crank it with the stock speakers to hear anything.

It sounds kind of dumb, I know, but would like to keep the factory stereo. Have looked at facia kits and what not, and due to the center dash design, they look quite ugly, or are cheap eBay brands.

Link to comment
https://www.sau.com.au/forums/topic/480851-stereo-fried/#findComment-7937110
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...