Jump to content
SAU Community

Recommended Posts

Hi,

if had the car for around 3000km now. Since the last 750km the transfer case started to leak. I have degreased it a few times and after a drive the drips are already hanging under the case. It’s red of color so I am sure it is ATF fluid. The case or gearbox has not been removed. I did change the gearbox oil to redline to get rid of a grind in fourth, but thats it. What are the most common causes of these cases to start leaking? 
 

Also when shifting I feel the car does a hard clunk even when letting the clutch get up slowly. Its like something gets a snap due to getting power from the engine. If that makes sense.

 

Hope someone can narrow it down for me. Can’t get the car in the air to verify more. Would need to go to a shop for that. 
 

cheers! 

C29372EA-2475-4AF5-892A-8D1CAB66725C.jpeg

14C6A8F0-4E6E-4F9F-A075-6E10D3B85D78.jpeg

4244E698-97EE-410C-89E0-EB3D3DD019F4.jpeg

Edited by T.Krol
Spelling error
1 hour ago, T.Krol said:

Hi,

if had the car for around 3000km now. Since the last 750km the transfer case started to leak. I have degreased it a few times and after a drive the drips are already hanging under the case. It’s red of color so I am sure it is ATF fluid. The case or gearbox has not been removed. I did change the gearbox oil to redline to get rid of a grind in fourth, but thats it. What are the most common causes of these cases to start leaking? 
 

Also when shifting I feel the car does a hard clunk even when letting the clutch get up slowly. Its like something gets a snap due to getting power from the engine. If that makes sense.

 

Hope someone can narrow it down for me. Can’t get the car in the air to verify more. Would need to go to a shop for that. 
 

cheers! 

C29372EA-2475-4AF5-892A-8D1CAB66725C.jpeg

14C6A8F0-4E6E-4F9F-A075-6E10D3B85D78.jpeg

4244E698-97EE-410C-89E0-EB3D3DD019F4.jpeg

Transmission or engine mounts need to be replaced if you get bad shift shock even with a lot of clutch slip. The back of the transfer case is probably leaking where the hose connects. It’s a high pressure hydraulic system so leaks are inevitable with age. To be sure you need to clean it off and then repressurize the system while under the car. 

  • Like 1
4 hours ago, joshuaho96 said:

Transmission or engine mounts need to be replaced if you get bad shift shock

And while that can be true, it is also possible that the clunk comes from the tailshaft centre bearing, from the diff CW&P lash, from CVs or the splines of the driveshafts into the hubs, etc. Also possible to be in the front drive stuff, but you wouldn't expect anything there to cause much noise on a normal takeoff.

  • Like 1
2 hours ago, GTSBoy said:

And while that can be true, it is also possible that the clunk comes from the tailshaft centre bearing, from the diff CW&P lash, from CVs or the splines of the driveshafts into the hubs, etc. Also possible to be in the front drive stuff, but you wouldn't expect anything there to cause much noise on a normal takeoff.

Good point, there’s a whole class of failures I forgot about that can also cause this. 

Thank you. I did read that the clunk noise can have many different causes. I guess the car needs to go in the air to figure that one out. I did go ahead and ordered this product: https://frenchysperformancegarage.com/collections/nissan-skyline-r32gt-r/products/fpg-bnr32-attesa-high-pressure-hose-replacement-with-optional-pressure-sensor-adapter-fpg-116?variant=42829932724402.

Since I am quit sure that the leak is coming from the Attesa hose. Also it might be leaking at the Atessa pump above the read diff, since I do get a bit of oil leaking from the right side area of the rear-diff, also red colored oil.

Is it harmful to drive every now and then with the car with this small leak?

 

24 minutes ago, T.Krol said:

Is it harmful to drive every now and then with the car with this small leak?

Not if it is actually just a small leak. Just watch your level. But, it could also transition into a really big leak at any moment, and that could be destructive.

so, as I mentioned in another thread on this leak recently, just back off the attessa line where it goes into the rear of the transfer case about 1/2 turn (or 12 turns if I can't type), then tighten it up again. Give everything a thorough degrease and see how it goes.

you can monitor the level of that fluid in the reservoir in the boot, just top it up if necessary

Reservoir was almost at max level without ign on. Topped it off but did a lil too much. I am 8-10mm above max level. Tried to put the ign on and see what it did but it stayed at that level. Is that allright to run the car with a little over max? Havnt turned the car on yet to check the level. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
    • The maxpeedingrods turbo is cheap and bolts on to stock parts. I think you just need a bigger silicone coupler for the intake. Its a cheap china turbo, but it's been running on mine for almost 3 years at 16-19 psi.
×
×
  • Create New...