Jump to content
SAU Community

Recommended Posts

Hey

I was driving my R32 GTR and I got held up in some trafic, I was idling at 1k and noticed my oil presure gauge sitting on 0. I thought to myself "FU*K", wtf is going on. When I slowly started to move it would slowly climb up, but the back to 0 when I came to a stop. When we started to move again and we got going, the gauge would sit normal, about 2. When I came to a stop again the gauge went to about 1 and stayed there this time. When I got home it was reading normal still, I got out of the car and looked under, I found no oil on the ground.

Can anyone tell me WTF this is or whats making this happen?

Thanks

CHASP

Link to comment
https://www.sau.com.au/forums/topic/48879-oil-presure-problems/
Share on other sites

did you have any trouble accellerating? revs were fluctuating and dropping at all?

i had a similar problem with my engine, turned out the radiator had ran dry of water (the cap was faulty), so check your radiator and fill her up if she's dry.

this might not be the case, but have a check anyhoo

Hey

Radiator is full

My revs are fine when driving but when I slow down they go to 0 and back to 1, sometimes it stalls, I asked my tunner and he said its something to do with my BOVs. But I havent asked my tunner about this as he is closed, so im trying to get my answer on SAU.

i would get mechanical oil pressure guage, and check it against that, they are only about 50 bux from supercrap or something....im not saying put a cheap ass guage in your gt-r im saying use it to see if yours is out, or your oil pump is sha99ed.....if at all possible have them hooked up at the same time to see any discrepancies(sp?) in readout.

Idle prob:

Have you had your throttle body off at all? ever?

Also could be ilde circuit faulty making revs jump around.

Or the speedo? :headspin:

I experience the same thing in my 32 GTS-t... it will sit REALLY low (not quite on 0) on the oil pressure guage, and then climb to slightly above 1/4 when driving around... i don't think i've ever see it go over 3/8th (between 1/4 and 1/2) on the guage... i'm hoping its just a faulty sender, not a shagged pump or something

Dont trust the reading of the stock oil pressure gauge.

I had a similiar prob when i had my idle issues with my sard 550cc injectors. Everytime the car would go into spastic idle and go back to normal idle the oil pressure gauge used to just go to 0 and sit there and sit there for ages till i turned the car off and on again, but the oil pressure was normal while the gauge said 0 pressure everytime.

The stock gauge is also said to be very slow reacting to a proper electronic oil pressue gauge.

Hey

I restarted the car later that night when it was just warm, and let it idle for 10-15min or so and the oil gauge sat on 2. When it was on 0 it would slowly climb when i reved it and moved a bit but then it droped back to 0, after the traffic cleared and I got going it was ok, when I came to a stop again it sat on 1 and didnt go to 0 again.

I didnt hear and werid sounds from the engine or anything.

My Revs are a diff matter I think, car idles at 1k and drives normal etc, when I slow down tho the revs dont stop at 1k again it goes all the way to 0 batt light flashers and then it comes back up to 1k again, somethimes it stalls. I am told this matter is something to do with the BOVs. Never use to happen and I was running 2 hks bovs and the stock pair (4 BOVs, Stocks sealed) I removed the stock ones as I was told it was for the best and now the revs do that. Pain in the ass it is, but thats not my may concern atm, the oil presure is and im pritty sure its the sender.

Thanks

CHASP

Got the same prob too in a 32 GTST. Oil pressure drops to zero (and the red low pressure light comes on) when I come to a stop, then picks up when I start moving again. Occasionally stalled too.

But I had a few oil leaks in the steering rack, sump, etc. Mechanic fixed that up the other day and hopefully that should fix it up.

Hey

I restarted the car later that night when it was just warm, and let it idle for 10-15min or so and the oil gauge sat on 2. When it was on 0 it would slowly climb when i reved it and moved a bit but then it droped back to 0, after the traffic cleared and I got going it was ok, when I came to a stop again it sat on 1 and didnt go to 0 again.

I didnt hear and werid sounds from the engine or anything.

My Revs are a diff matter I think, car idles at 1k and drives normal etc, when I slow down tho the revs dont stop at 1k again it goes all the way to 0 batt light flashers and then it comes back up to 1k again, somethimes it stalls. I am told this matter is something to do with the BOVs. Never use to happen and I was running 2 hks bovs and the stock pair (4 BOVs, Stocks sealed) I removed the stock ones as I was told it was for the best and now the revs do that. Pain in the ass it is, but thats not my may concern atm, the oil presure is and im pritty sure its the sender.

Thanks

CHASP

Who ever told you to remove the stock gtr bov's is an idiot. Put the stock gtr bov's back on as they have been used on gtr's and supras with over 500kw@wheels withput any problems.

Who ever told you to remove the stock gtr bov's is an idiot. Put the stock gtr bov's back on as they have been used on gtr's and supras with over 500kw@wheels withput any problems.

Damn, I was told by a few ppl to remove them. Damn its always my luck and I sold them tooo :) might have to get me another pair. Will R33 or R34 GTR ones fit just incase thats all I can find??

CHASP

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
    • Unsolicited advice? Keep the engine as close to stock as you can. Nothing wrong with adding some boost and making a little more power, but given where you are, you really don't want to try to make it into a monster. I can't imagine the roads are up to it, and the lack of locla support when it grenades will be a ball ache. FWIW, If there is a dyno around that you can access, then brand new injectors are a good idea, which will lead you to (at least) putting a Nistune in it, which will allow you to put an R35 AFM on it, all of which will make it possible to make it much much nicer to drive and live with.
    • List all of your mods. It sounds like an aftermarket ECU hitting rev limiter. Like a valet mode, or a cold rpm limiter? 
    • @Kapr Haha yeah thats the one. I missed that you had a built up engine, I wouldn't want to run it on there either then. It was good in my situation just to replace the original turbo on a stock engine. @MBS206Yep definitely not a replacement for anything name brand
    • You are selling this? I have never bought something from marketplace...i dont know if i trust that enough. And the price is little bit "too" good...
×
×
  • Create New...