Jump to content
SAU Community

Recommended Posts

saw RBPOWA (SP) on glynburn road.

That would be me. I take it u were in the s2 rs?

Also spotted a s2 bayside blue at the bp on lower north east rd as I pulled in to get fuel u were leaving

white C34 with gold/bronze rims weaving in and out of traffic, from the M4 all the way up to ryde this afternoon. in my black 34, no love shown =(

:action-smiley-069: hi Chris, sorry too busy hooning to wave :) Nice 34 BTW

Spotted a Black S2 Stagea a few times now around Burwood East over last 2-3months on Highbury Rd and Blackburn Rd

Same with a White S2, also keep seeing a White M35 in same area. Sometimes up on Springvale Rd.

Exchanged headlights, waves, toot the horn a few times.

Yellow S2 Stagea with R34 kit also in same area also.

Got a thumbs up and a wave from the bloke with the other silver m35 down the end of Targo Rd on the weekend.

Dave, it wasn't you I saw the other night on Gilba Road (crossing Targo) and then again about 20mins later in Toongabbie near the servo on Cornelia?

Dave, it wasn't you I saw the other night on Gilba Road (crossing Targo) and then again about 20mins later in Toongabbie near the servo on Cornelia?

Hey mate, yeh I saw your post, and the times were near when I was getting around those areas, but I turn left from Targo onto Gilba, and you mentioned Junia and Cornelia? I was parked in the servo on Cornelia that's opposite toongabbie shops, I just re-read your post I thought u said Lucretia and Cornelia, not Junia, but yeh for sure that would have been me then :)

Edited by DaveM35

Spotted a Black S2 Stagea a few times now around Burwood East over last 2-3months on Highbury Rd and Blackburn Rd

Same with a White S2, also keep seeing a White M35 in same area. Sometimes up on Springvale Rd.

Exchanged headlights, waves, toot the horn a few times.

Yellow S2 Stagea with R34 kit also in same area also.

That was me in the Black C34.....probably wont be seeing you on Highbury Rd anymore as Im not working at the same place anymore so taking a different route to work now :P

Spotted a white M35, looked like aero kit on King Georges Rd at 11am right near AutoStyle, was dumped on black rims with copper brembos, really nice looking ride.

Then around 1:30 saw a yellow c34 on Sunnyholt rd Blacktown, near Vardys Rd.

Saw a black M35, most likely an AXIS, on the M2 Motorway heading south-west between the Pennant Hills Road and Windsor Road exits, roughly 5.45pm last night. I was heading in the other direction and about to get off the M2 at Pennant Hills Road.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...