Jump to content
SAU Community

November SAU NSW Monthly Dinner 25/11/04- PIZZZAAA!!!!!11


Recommended Posts

Okay kids

How about a dinner night at Nick's Pizza in lindfield.

Thursday 25th November

7:30pm

We will have to book so post your interest.

Nicks Pizza

374 Pacific Hwy Lindfield NSW 2070

ph: (02) 9416 2276

Parking behind coles..

MAP

http://www.skylinesaustralia.com/forums/ca...?do=attend&e=86

RSVP in the calender.

Attendance list so far

* carlo

* red900ss

* Zebbie

* Duncan

* GTRSRULE!!!

* Ash

* Unregistered (??????)

* mmmgtir

* ecl

* 4DoorGTR

* sewid

* Blitz

* Oz GTR97V

* someonestolecc

* Ceffo

If you cant make it and your on this list then let us know, if you are coming but not on the list then RSVP as I will book tomorrow.

This is looking like the biggest SAU event since the show and shine. :D

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

hmmmm.....is there ANY chance for this to happen on the 26th ???

my last exam is on the 26th..and its in the morning too....so i cant make 25th.....

hehe not asking you to change the date cause of one person....but just wondering if its possible to have it on the 26th.... :D

I'll attend this one. Let's talk, why not?

I guess 25th would be ok for me. It is kind of a thursday night institution though...

BTW is this place BYO?

Richard




  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...