Jump to content
SAU Community

Recommended Posts

List as of Castrol oils as follows

Engine Castrol formula R 10/60

Gearbox Syntrans 75w/85

Transfer case Transmax Z

Front Diff Syntrax 75w/90

Rear diff SAF-XA 80W-140

4wd TRANSMAX Z

pwr steer TRANSMAX Z

Brake super response dot 4

Clutch super response dot 4

This is what i use in my own GTR and it gets a hard life and still lives

Theo

hi, I was told by Gavin that you can use dexron III for the attessa resovoir, I tried getting hold of this 'nissan special power steering fluid' from two nissan dealers in Brisbane and one of them used to sell the R32 GTRS and they didnt have a clue about the fluid.

Were you able to actually get some?

I have used the dexron III in my attessa and if anything the 4wd is coming on much quicker (also have new tyres which are a week old - which may be contributing, just getting grippy now).

P.S. Make sure the rear diff has Limited slip dif oil in it, from memory the castrol oil recomendation card in the shop is wrong. It should be LSX 90, i actually emailed them to find out, if you want to be sure email them to find specs.

above is in regard to an R32 GTS4

Stephen

coolant: Nulon. The green one. I think they just call it "nulon long-life". It's good sh1t and was recomended to me by the guy who built my calsonic twin core radiator. He said in his experience it is also not reactive with other coolants, which is important since you wont know what was in it.

mmmgtir: Thanks for the tip. I have also heard that Redline Water Wetter is good stuff too.

Parag0n: I am planning to get the radiator flushed and will dump all the water/coolant, and start again with new coolant and demineralised water :)

LW.

Ok, just looked through the service manual and it recommends the following for the diffs:

Front Final Drive (F160): GL-5 85W-90 (~1l)

Rear Final Drive (R200): GL-5 80W-90 (1.5l)

Rather irritating the front and rear have different requirements. 80W-90 seems to be easy enough to find; anyone know who makes an 85W-90 product?

Edit: Just thinking about it, the front is open and the rear is mechanical. So should the front oil just be a standard diff/gear oil, and the rear a special LSD oil (ie. additional friction additives)?

Lucien.

You can use LSD oil in the front as well .

I use premixed coolant saves the macking around to get the water .

Basicaly any brand as long as its minimum 33% , 50 % is better and it will last longer too .

You will need about 8 lts if you empty the heater as well as the block .

Okie Dokie. Having now changed the gearbox and transfer case oils I can say the following:

* My gearbox needed just over 4 litres of oil. If you plan to use Redline Lightweight Shockproof be aware that the large containers are 3.7l not 4l bottles. I bought an additional an additional small bottle (~0.9l) so I had some extra.

* My transfer case needed about 1.5 litres of oil. I used Castrol Transmax Z: I purchased two of the 1 litre bottles.

Interestingly the gearbox oil looked filthy while the transfer case oil looked almost new. Thankfully there were almost no shavings whatsoever on the welsh plug magnets for either :P

I am still entirely confused about what diff oil to go for. I double checked the Nissan workshop manual and it lists standard diff oil for the front and LSD oil for the rear. I can quite easily get 85W-140 and SAE90 LSD oils, but nowhere seems to stock anything close to 85W-90.

Finally, can someone explain the ATESSA actuator too me? Its different to the rear diff and transfer case, right? I might see if I can track down some of this "Nissan Power Steering Fluid Special" unless anyone can recommend something else (or counter the comment made by GTR V)?

Cheers,

Lucien.

  • 2 weeks later...

Slightly old post - but anyhow - I obtained some "Special Blend Matic-D" ATF from my local Nissan dealer (Moorabbin, VIC out on Napean Hwy). Number listed on front of the bottle is 10130-89901A if that helps at all.

Paul

Okie Dokie.  Having now changed the gearbox and transfer case oils I can say the following:

* My gearbox needed just over 4 litres of oil.  If you plan to use Redline Lightweight Shockproof be aware that the large containers are 3.7l not 4l bottles.  I bought an additional an additional small bottle (~0.9l) so I had some extra.

* My transfer case needed about 1.5 litres of oil.  I used Castrol Transmax Z: I purchased two of the 1 litre bottles.

Interestingly the gearbox oil looked filthy while the transfer case oil looked almost new.  Thankfully there were almost no shavings whatsoever on the welsh plug magnets for either :thumbsup:

I am still entirely confused about what diff oil to go for.  I double checked the Nissan workshop manual and it lists standard diff oil for the front and LSD oil for the rear.  I can quite easily get 85W-140 and SAE90 LSD oils, but nowhere seems to stock anything close to 85W-90.

Finally, can someone explain the ATESSA actuator too me? Its different to the rear diff and transfer case, right?  I might see if I can track down some of this "Nissan Power Steering Fluid Special" unless anyone can recommend something else (or counter the comment made by GTR V)?

Cheers,

Lucien.

Slightly old post - but anyhow - I obtained some "Special Blend Matic-D" ATF from my local Nissan dealer (Moorabbin, VIC out on Napean Hwy). Number listed on front of the bottle is 10130-89901A if that helps at all.

Paul

Thanks Paul: does it have any other marking on the packet/bottle?

LW.

I only have a 1 litre bottle (about $8) but I think they said they had a 4 or 5 litre available.

Black squarish bottle - white sticker usual red/blue stripes - says:

Nissan

Automatic Transmission Fluid

Special Blend

Matic-D

Part number on the invoice is the number in my last post. Bottle also mentions to use it as power steering fluid for R32 GTR.

They told me that this is the stuff to use for the HICAS reservoir.

Paul

Thanks Paul: does it have any other marking on the packet/bottle?

LW.

  • 1 year later...

Hi after reading this post im now a little confused, WTF ???

I have been running transmax z (ATF) in my front diff of my 33GTRVSPEC

I looked it up at auto Pro in Newcastle in one of there oil charts and transmax z was recomended for the 32GTR front diff.

I also spoke to Guys that tune my car and they also recomended transmax z and aparently they put it in all the GTR's ,,,

is anyone else running transmax z ( ATF ) in there front diff ?????

should i change it ASAP ???

Thanks

  • 3 years later...
The reason I posted it up the 2nd time is because you asked the question after I had already put the answer there the 1st time.

I am only tryimg to help you.

GTR V

I just recently brought 5 litres of nissan D matic fluid for my transfer case. It states on the back of the container that it is also used in the R32 gtr power sterring. It cost me $66.00 from nissan.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...