Jump to content
SAU Community

Recommended Posts

I think the smoke is getting worse. I could take more pictures but all you would see is white/grey now. Literally, Looking out the window, northbridge has disappeared as has kings park.

Here is a pic looking east down st georges terrace. Again, apologise for the quality as it's from my phone.

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

Well its not quite showing up on teh IR sat yet. Which means its not too hot. Wish i could zoom in but i managed to get this ala sbs close time.

http://www.bom.gov.au/products/IDX1124.shtml

There is a little bit of heat on the coast there but i think thats normal.

Just for comparative purposes, here are two photos (camera phone) from a couple of minutes ago. You can see that it's got considerably worse than the photos I posted around 9am this morning as far as smoke cover goes.

not sure...

but u can actually see shiz now.. thank god! the city is clearing up and u can see where the sea breeze is up too....

fire engine went down the terrace just then.... intersting :P

-pie




  • Similar Content

  • Latest Posts

    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
    • It's been quite the ordeal but hey, at least you figured it out.
    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
×
×
  • Create New...