Jump to content
SAU Community

Recommended Posts

Does ne1 know of a way to may the lights on my R33 clear again it looks filthy when you turn them on!!!

The plastic has faded and is starting to crack =(

I have heard of plastic polish does ne1 know if this works?

Does ne1 know where i can get a replacement set for a decent price as i have been quoted $1000 for a new set!!! =(

Link to comment
https://www.sau.com.au/forums/topic/69345-fixing-cracked-and-faded-lights/
Share on other sites

I use Meguiars ScratchX and it does the job nicely. It's a little bit pricey (about $20 a tube), but bonus is that you can use it on the rest of the car as well to get rid of light scratches, whereas you cannot with other things like plastic polish, toothpaste, Gumption etc.

  • 6 months later...
  • 1 year later...

I do this at work, bit scary at first but it works.... If they're really bad, sandpaper first.... work your way up through the grades of wet and dry to 1500 or 2000.... then silicone free polish. Takes about an hour a pair, even on the worst condition lights.

  • 2 weeks later...

Try using silvo from Coles or woolies. about $8 for a can that will last you two lifetimes.

Using a cotton cloth... put some on it then rub in small circles with pressure.

Then buff off with a clean cotton rag.

Finally, to help protect the finish... add some car polish and then polish off as per usual.

This will cure the fading/yellowing problem but not the cracking.

Plastic gets old and doesn't like the sun... it cant be helped.

Edited by negoshi8or

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...