Jump to content
SAU Community

Recommended Posts

95 r33 skyline gtst

rego ends july

car has been rear ended pretty bad... in between the 2 rear wheels the whole back is squashed in just back to where the back seats are.. roof is not damage.. not sure if car is repairable or not. everything from the backseat to the front is in good condition.. car starts and all.. engine has around 105,000 kms. but car has NEVER been boosted so the front cut is immmaculate... car has a 3`turbo back exhuast.. i think the dump and front pipe are still fine. has airbags, cliamte control... etc...car is silver..the car is fully stock with some unknown brand bov.. it will come with a white front bar.. tahst all i can think of.. located in west syd.. will get pics tomorrow.. btw car is manual... gearbox and engine in a1 condition

looking for around 7.5k ono

ALSO sideskirts and front bar not included...also will sell with 17`rims on the car

pics here

http://www.skylinesaustralia.com/photopost...500&ppuser=7293

hey guys.. i am getting pics taking tonite.... yes the stock rims and tyres are all fine... havnt got a quote to get it fixed but had a mechanical friend looked at it and he said if the damage is repairable it would cost around 6-7g to repair.....car still has rego so if u can repair it then there is no hassle going through inspection n stuff.. good for panel beaters or wreckage

Big dollar fix if it isnt a write off:

Rear Diff Complete - $800

Rear 1/2 Complete - >$2000

Maybe good buy at $5000-$6000 to fix a R33 that has had a front end stack.

update guys... sideskirts kinda stuck so its hard to take out.. selling whole wreck minus front bar thats all...so u get the sideskirts as well

also liek i said.. selling complete.. so dnt ask me for separete parts

thanks

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...