Jump to content
SAU Community

Recommended Posts

I'm not really bias I think... the rexy does feel gutless at low rpm. Go to your subaru dealer and check for yourself...

I'd be the first to admit if it had better power all round..

Obviously the grip is great but compared to the R33 with a few minor mods the rexy felt like a slower car

  • Replies 214
  • Created
  • Last Reply

Top Posters In This Topic

Dush - your wang is big, don't get me wrong.. but my wang is bigger.

Ben - what do you consider low rpm?

If both cars red line at 7000rpm then mid rev range is 3500rpm.

so I assume by low rpm, you are talking about 2000rpm.

then YES. The 2.5L with 9:1 compression and relatively small ball bearing turbo charger has more get up and go when compared to the 2L in the wrx.

but this thread is not about which car gets to 3000rpm quicker.

it is which car is faster in a race.

most legal races start from a standing start, and end 402m later.

will the more torque at 2000rpm help you there?

or are you a Great Western Raceway kinda guy?

in my expeirences i have beat a my03 wrx in my r33 gtst. he had me of the mark but then as expected i plled him back and won .

this car was stock and all mine has is a boost controller running 10 pound.

they will allways get you of the line (awd) but if you can drive and launch your skyline well they shouldnt get too far away

JUST BUY A SKYLINE

Hey Ben, i think they actually got that shitty vn commie into the 11's!

As for lag. my rex with the standard turbo and tb exhaust could reach 17 psi by 2500 rpm, is that laggy?

My god! They succeeded in polishing the turd.

PHATGTR-My old MY00 WRX with the stock TD04 and a full 3" MSR HiTech exhaust would make 1.1 bar by 2600rpm in higher gears. Fatz (NSW Forums) has driven it and could comment for an unbiased opinion. Then again he'd probably just say, "It's a bloody Hyundai piece of crap" so maybe his opinion isn't really unbiased either. :)

(yet another) Ben

  • 2 weeks later...

I owned a MY98 for 2 years and have just purchased a stock SII R33 and as much as it hurts me to say it, the WRX was much more impressive when it comes to performance. However thats probably the only more impressive thing about the WRX, what is not impressive is the drivetrain, they should have made it out of glass it would have been stronger.

I guess what i am trying to say is while your mates WRX is in the shop with the gearbox or clutch out (depends on what week it is) you will be thinking what a great decision you have made.

Gary

I think the it would be a close race stock for stock.

I raced a R33 gtst he had same mods as me really like front mount, exhaust, fuel pump etc cause i sorta know him.....i beat him from 50kph rolling start to 180kph and i got a RB20DET in my silvia at 10psi and i short shifted each gear due to my misfire problem.

But we have a mate with WRX manual and that hoots.

- Luke

it all depends on the driver too, i raced some random who was in a rex vs my 33, and he couldnt get traction off the line, then he couldnt catch me so no point comparing high performance cars without considering low performance drivers

I owned a MY98 for 2 years and have just purchased a stock SII R33 and as much as it hurts me to say it, the WRX was much more impressive when it comes to performance. However thats probably the only more impressive thing about the WRX, what is not impressive is the drivetrain, they should have made it out of glass it would have been stronger.

I guess what i am trying to say is while your mates WRX is in the shop with the gearbox or clutch out (depends on what week it is) you will be thinking what a great decision you have made.

Gary

I still don't know what makes people think the subaru drivetrains are so weak.

I've had 3 wrxs, all had a fair bit of power, and copped a hiding and never had a gearbox problem.

I had an MY96 which has the weakest gearbox of them all. Took it to the drags a few times and was good enough for low 13s...never had a gearbox problem.

Also had an MY00 STI with a bit over 200awkw. Took it to the drags lots of times. Had a best time of 12.6 (with no traction) and never ran slower than 12.9. Never had a gearbox problem in that either.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Power is fed to the ECU when the ignition switch is switched to IGN, at terminal 58. That same wire also connects to the ECCS relay to provide both the coil power and the contact side. When the ECU sees power at 58 it switches 16 to earth, which pulls the ECCS relay on, which feeds main power into the ECU and also to a bunch of other things. None of this is directly involved in the fuel pump - it just has to happen first. The ECU will pull terminal 18 to earth when it wants the fuel pump to run. This allows the fuel pump relay to pull in, which switches power on into the rest of the fuel pump control equipment. The fuel pump control regulator is controlled from terminal 104 on the ECU and is switched high or low depending on whether the ECU thinks the pump needs to run high or low. (I don't know which way around that is, and it really doesn't matter right now). The fuel pump control reg is really just a resistor that controls how the power through the pump goes to earth. Either straight to earth, or via the resistor. This part doesn't matter much to us today. The power to the fuel pump relay comes from one of the switched wires from the IGN switch and fusebox that is not shown off to the left of this page. That power runs the fuel pump relay coil and a number of other engine peripherals. Those peripherals don't really matter. All that matters is that there should be power available at the relay when the key is in the right position. At least - I think it's switched. If it's not switched, then power will be there all the time. Either way, if you don't have power there when you need it (ie, key on) then it won't work. The input-output switching side of the relay gains its power from a line similar (but not the same as) the one that feeds the ECU. SO I presume that is switched. Again, if there is not power there when you need it, then you have to look upstream. And... the upshot of all that? There is no "ground" at the fuel pump relay. Where you say: and say that pin 1 Black/Pink is ground, that is not true. The ECU trigger is AF73, is black/pink, and is the "ground". When the ECU says it is. The Blue/White wire is the "constant" 12V to power the relay's coil. And when I say "constant", I mean it may well only be on when the key is on. As I said above. So, when the ECU says not to be running the pump (which is any time after about 3s of switching on, with no crank signal or engine speed yet), then you should see 12V at both 1 and 2. Because the 12V will be all the way up to the ECU terminal 18, waiting to be switched to ground. When the ECU switches the fuel pump on, then AF73 should go to ~0V, having been switched to ground and the voltage drop now occurring over the relay coil. 3 & 5 are easy. 5 is the other "constant" 12V, that may or may not be constant but will very much want to be there when the key is on. Same as above. 3 goes to the pump. There should never be 12V visible at 3 unless the relay is pulled in. As to where the immobiliser might have been spliced into all this.... It will either have to be on wire AF70 or AF71, whichever is most accessible near the alarm. Given that all those wires run from the engine bay fusebox or the ECU, via the driver's area to the rear of the car, it could really be either. AF70 will be the same colour from the appropriate fuse all the way to the pump. If it has been cut and is dangling, you should be able to see that  in that area somewhere. Same with AF71.   You really should be able to force the pump to run. Just jump 12V onto AF72 and it should go. That will prove that the pump itself is willing to go along with you when you sort out the upstream. You really should be able to force the fuel pump relay on. Just short AF73 to earth when the key is on. If the pump runs, then the relay is fine, and all the power up to both inputs on the relay is fine. If it doesn't run (and given that you checked the relay itself actually works) then one or both of AF70 and AF71 are not bringing power to the game.
    • @PranK can you elaborate further on the Colorlock Dye? The website has a lot of options. I'm sure you've done all the research. I have old genuine leather seats that I have bought various refurbing creams and such, but never a dye. Any info on how long it lasts? Does it wash out? Is it a hassle? What product do I actually need? Am I just buying this kit and following the steps the page advises or something else? https://www.colourlockaustralia.com.au/colourlock-leather-repair-kit-dye.html
    • These going to fit over the big brakes? I'd be reeeeeeeeaaaall hesitant to believe so.
    • The leather work properly stunned me. Again, I am thankful that the leather was in such good condition. I'm not sure what the indent is at the top of the passenger seat. Like somebody was sitting in it with a golf ball between their shoulders. The wheels are more grey than silver now and missing a lot of gloss.  Here's one with nice silver wheels.
    • It's amazing how well the works on the leather seats. Looks mint. Looking forward to see how you go with the wheels. They do suit the car! Gutter rash is easy to fix, but I'm curious about getting the colour done.
×
×
  • Create New...