Jump to content
SAU Community

Recommended Posts

  • Replies 94
  • Created
  • Last Reply

Top Posters In This Topic

Okay this is how i see it;

Most stock R33 25t's i've seen run will run low 14's with crappy 60ft's between 2.0 - 2.5 put a set of slicks on it on stock rims i'm sure you could get 60ft down to 1.75 - 1.8 which should give you enough for low 13's and remember that elf is going to give you more power.

I find it hard to believe even a high 13 out of a stocker..

mine has a full exhaust ('cept the dump) with some nice suspension mods, i get 2.25 60' times.... (235 tyres) and I only managed a 14.86 BEST.

with a POD, and boost to 10psi I think a high 13 would be possible. but not stock. I'd like to see someone's timeslip for a STOCKER!?!?!

Originally posted by Strich9ine

I find it hard to believe even a high 13 out of a stocker..

mine has a full exhaust ('cept the dump) with some nice suspension mods, i get 2.25 60' times.... (235 tyres) and I only managed a 14.86 BEST.

with a POD, and boost to 10psi I think a high 13 would be possible. but not stock. I'd like to see someone's timeslip for a STOCKER!?!?!

Just cos you can't drive, doesn't mean that the car isn't capable of better :mad:;):D :D :P

I managed a 14.3 @ 95mph with spinning tyres in my stock R33 (air filter and cat back exhaust)... With good traction off the line (slicks as kabab suggested), a high 13 is very possible.

Low 13? No chance in hell.

Yeah but thoes mods would barely increase any power..

I still think low 13's are possible, most of you guys who go out have really stiff suspension to which doesn't help at all either...

Also another factor GTR's can run thoes time with abit more power stock which the elf would make up for and with slicks on stock suspension your 60ft's should be similar if not better.

not much differance? go learn what mods do to a car kabab.. i woulda thought u'd have half a clue considering how long u been on forums. Exhausts.. especially on turbo cars help, not just by the better flow but by the inherent boost increase which comes with this better flow etc. So an exhaust is a decent mod for a car. put a stock exhaust on and see how asthmatic your car feels especially top end.

look at all these people with mods tho.... hicks is pulling 13.7 (BEST)

and he's got 14psi, POD, full zorst, FMIC.. all that...

if you can pull a high 13 stock, why spend $2500 on those mods ?

hence my theory of not getting a stocker in the 13s....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
×
×
  • Create New...