Jump to content
SAU Community

  

21 members have voted

You do not have permission to vote in this poll, or see the poll results. Please sign in or register to vote in this poll.

Recommended Posts

In your opinon, should the elected parliament be the sole law-makers in Australia?

Why should the elected parliament be the sole law-makers in Australia?

Should other bodies such as the executive (government) and the judicial body (courts) make laws?

If yes, why should these bodies make laws that against the theory of separation of powers popularised by Montesquieu 1748?

Link to comment
https://www.sau.com.au/forums/topic/78819-australia-legal-system/
Share on other sites

In your opinon, should the elected parliament be the sole law-makers in Australia?

Why should the elected parliament be the sole law-makers in Australia?

Should other bodies such as the executive (government) and the judicial body (courts) make laws?

If yes, why should these bodies make laws that against the theory of separation of powers popularised by Montesquieu 1748?

Sorry I didn't vote as there was no WTF? option

To answer briefly

"Why should the elected parliament be the sole law-makers in Australia?"

Because in the Westminster system of Government they are the only ELECTED body of those you mentioned and are responsible to the people.

What do you suggest Communism...?...silly boy

Should other bodies such as the executive (government) and the judicial body (courts) make laws??

Judges and lawyers are too busy rorting the Tax system and avoiding the ATO.

And speaking of the ATO an executive branch of the govt. they are already a law unto themselves .

  • 3 weeks later...


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...