Jump to content
SAU Community

Recommended Posts

hey all,

im looking for a R32 GTR to buy, ive been test driving quite a few, but i have some issues and questions that maybe someone knows something about??

- should i steer clear of a rusty underbody?

- is slightly bent weld seam undercar a problem?

- is slightly dented/bumped chassis rails a problem?

- one car crunched slightly going into 5th after pushing it a bit in 4th what does that mean?

- one has had factory ecu tuned in japan and is running a catless O2 sensorless exhaust...?

- one has aftermarket clutch and makes a strange noise from front/transmission when taking off under 2500rpm?

- are things like the door and window seals, easy/expensive to replace?

- is the shrunken inside window seal(along bottom of window) easy/expensive to replace?

- is that damn bubble they all get in the dash infront of the passenger easy/expensive to fix?

thanks for any info

Dan

Link to comment
https://www.sau.com.au/forums/topic/79496-buying-a-gtr-problems/
Share on other sites

rusty underbody -> yes

bent/dented/bumped chassis rails -> yes

crunching into 5th -> worn synchros on 4th and 5th gears are common on the gtr box. it could be as simple as doing an oil change on the gearbox, or it may be fully stuffed

catless exhaust, no o2 sensor? wtf ? that cant even be registered

strange noise could be just the noise a multi plate clutch makes, or it could be a problem with the front diff/transfer case ?

door/window seals are easier to replace than most other thinsg :D

bubble ?

hey all,

im looking for a R32 GTR to buy, ive been test driving quite a few, but i have some issues and questions that maybe someone knows something about??

- should i steer clear of a rusty underbody?

- is slightly bent weld seam undercar a problem?

- is slightly dented/bumped chassis rails a problem?

- one car crunched slightly going into 5th after pushing it a bit in 4th what does that mean?

- one has had factory ecu tuned in japan and is running a catless O2 sensorless exhaust...?

- one has aftermarket clutch and makes a strange noise from front/transmission when taking off under 2500rpm?

- are things like the door and window seals, easy/expensive to replace?

- is the shrunken inside window seal(along bottom of window) easy/expensive to replace?

- is that damn bubble they all get in the dash infront of the passenger easy/expensive to fix?

thanks for any info

Dan

Ok I will answer you questions as you typed them:

- should i steer clear of a rusty underbody?

rust is not good. if there are a few little bits that' not uncommon and if treated wont pose a problem. if there is lots, or it is more than just surface rust, then probably best to keep looking, or really consider all the aspects of the car

- is slightly bent weld seam undercar a problem?

I assume you mean the seam that is just inside the side skirts. this is not a problem. they mostly get flattend from being put on hoists, jacked up etc. no big deal.

- is slightly dented/bumped chassis rails a problem?

again, providing the car is still straight this is no big deal. can be caused by improperly placed/sized jack stands, being lifted with a forklift or a jack. or can be caused by hitting something (ie big rock or gutter). slight dents and bumps appart from looking unsightly are not a problem. just make sure it doesn't start to rust there.

- one car crunched slightly going into 5th after pushing it a bit in 4th what does that mean?

could be a couple of things, could be worn synchros, could be some debris in the box (which would indicated something else may be broken), could just be you shifted too quickly, could be that the clutch wasn't full dissengaged (which could be you or could be a clutch problem) it's hard to say

- one has had factory ecu tuned in japan and is running a catless O2 sensorless exhaust...?

ok, I would say it does have the 02 sensors. they are in the dump pipes just after the turbo. the sensor you are most likely thinking off is the cat temp sensor which does nothing other than trigger a warning light to warn you not to park in long grass! it's the one that is located in the cat. having no cat means you will have to buy and fit one. have a jap tuned ecu could be good or bad. most of them seem to like to run very rich mixtures and high levels of ignition advance which could be bad. they tend to give a very responsive feeling car on stock boost, but can cause detonation once you wind the boost up.

- one has aftermarket clutch and makes a strange noise from front/transmission when taking off under 2500rpm?

I have no idea mate. is it just squel? some brass clutches do squel on take off.

- are things like the door and window seals, easy/expensive to replace?

- is the shrunken inside window seal(along bottom of window) easy/expensive to replace?

not really. I think the seals will be a few hunderd dollars all up. but this is pretty common to most R32GTRs. even the newest 32GTR is now more than 10 years old.

- is that damn bubble they all get in the dash infront of the passenger easy/expensive to fix?

apparently you can inject glue into it to glue it down. if that works then it would be a cheap fix. if not it will need to be re-skinned. not so cheap.

thanks for the quick replies guys!

the 5th gear shift is definately not me, i did it several times, but appeared only when making a higher rev change. when just cruising it was fine.

-strange noise from front/transmission...

this was kinda like a rattle, but a solid rattle that shuddered the car a little, (as opposed to a tinny exhaust problem type rattle), it sounded like something was loose or broken, almost as if the clutch wasn't lining up properly or something like that.

it also seemed to make the chassis twist a little? or at least made the floor under my feet move a bit?? if that makes any sense?!

cheers

The problem with buying any cars that have any sort of chassis damage is that the chassis can creak, or bend because it is slightly warped or damaged.

I had one with some 'slight' damage to one of the rails, and let me tell you, it made a helluva creaking noise whenever i went over a speed hump :D

hmmm thats an interesting point, i didnt think to attribute the noises to accident damage, only mistreatment. if only i could foot the bill for a r34 i wouldnt have these silly issues!

well they're 2nd hand too so i suppose i would....

also...

ive noticed a lot of r32's have this gap at the back on the parcel shelf behind the top of the back seat, and the seat is generally a bit loose... is this just because they havent been fitted back on properly? i dont know why they would be taken off in the first place!?

and the wind noise at 80kms+ is this common in all R32's? i noticed the little window shield visor thingy around the door frame seems to stop it from happening, but if its removed, or isn't there at all, can the wind noise be stopped??

dan

also...

ive noticed a lot of r32's have this gap at the back on the parcel shelf behind the top of the back seat, and the seat is generally a bit loose... is this just because they havent been fitted back on properly? i dont know why they would be taken off in the first place!?

and the wind noise at 80kms+ is this common in all R32's? i noticed the little window shield visor thingy around the door frame seems to stop it from happening, but if its removed, or isn't there at all, can the wind noise be stopped??

yeah mine has the gap between the shelf and the back seat. As they are not a split fold design the backrest hangs on these little metal hooks. These are so pathetically weak its not funny, they fold up if you look at them wrong.

If you mess around with them enough times trying to get it right like me, theyr'e never the same hence the gap....

Mine was removed to run stereo cable etc so its probably the same. Get dark window tint and you can't see it. Its not a problem from the inside....

AS for the wind noise, yes mine is very noisy, I have messed around with the window alignment trying to get it right and that's what's caused the wind noise. Maybe they need to be re done? nothing major though. You'll find most pillarless cars have a fair degree of wind noise.

As for the dents and such underneath. You have to remember these are not new cars anymore so some accidents (little ones like clipping curbs) of bottoming out will more then likely have happened. My R32 has a few little dings and stuff underneath, its pretty common. I wouldn't worry unless the damage is severe. The car is old so it may or may not creak regardless. Mine does not. These cars are not cheap for no reason! they're oldies but goodies.

Mine also has a litttle bit of rust i'll be fixing. Again, an age thing, if its small and fixable its still worth it, mine has no other rust other then a 50 cent sized piece right behind the drivers front wheel about a foot back on the underside.. Several I've seen also have it....

thanks bazelinerz!

the gtr i had a look at had a fair amount of rust,

the fuel tank was bubbley all over under the paint with rust, the whole exhaust was rusty, the whole underbody was rusty, the chassis rails and weld seams everything... and had a spot peeping through the top of the side skirt in the door jamb...

i think i'll give that particular GTR a miss....

re bubble:

that's a neat idea with the injection of glue, but how do you know that behind it is something appropriate to be glued? ie. how do you know that behind there is a piece of plastic, and the material hasn't split in half? the bubble on my passenger side is pretty hard to push down so i'm not sure anything like glue would hold for long. i try to ignore it.

re bubble:

that's a neat idea with the injection of glue, but how do you know that behind it is something appropriate to be glued? ie. how do you know that behind there is a piece of plastic, and the material hasn't split in half? the bubble on my passenger side is pretty hard to push down so i'm not sure anything like glue would hold for long. i try to ignore it.

I have the bubble too! Are you saying it's not supposed to be there? Nah it's just one of those things like the broken air con vents...

:confused:

spot on about the gap for the back seat. Remember it needs to be taken out if anyone is putting a stereo/wiring etc in.

As far as the wind noise - thats caues of the stock mirrors. My last car (32 GTS-T) had this however my GTR doesn't because it has Ganador mirrors.

also...

ive noticed a lot of r32's have this gap at the back on the parcel shelf behind the top of the back seat, and the seat is generally a bit loose... is this just because they havent been fitted back on properly? i dont know why they would be taken off in the first place!?

and the wind noise at 80kms+ is this common in all R32's? i noticed the little window shield visor thingy around the door frame seems to stop it from happening, but if its removed, or isn't there at all, can the wind noise be stopped??

dan

Its called the "whether strip".  Try Nissan to confirm prices

Lucien.

Cheers dude,

I rang Nissan and they said there are 5 versions? WTF? they can't get prices they need to ring Japan. Pathetic.

I'm guessing I'm gonna need a part number for them to have half a clue what I want.....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
×
×
  • Create New...