Jump to content
SAU Community

Recommended Posts

Turning 23 this year.. been with my missus for 5 years this dec. im getting drilled hard about spending to much money on my car.. so i think its the mature thing to put it up for sale and see what happens.. I not as phycotic as i use to be back in the days when i had my old VL. i dont enjoy driving this .. its only seen the road 3 times since 100% completion.

its done an 11.6 down the 1.4 while experiance a problem with the glide.. ( the shifter cable was not adjusted enough and woudl not enable 2nd gear ).. the 2 speed glide is fine on the street no issues at all with . you would be shocked at how smooth it is.. i woudl prefer it over a 3 speed trimatic any day!! and they r tuff as nails.

The main purpose of the car being built would have to be to keep it sleeperish as posible inside and out.. from the exterior no one could tell its turbo untill they hear the thing spool... even in the engine bay ive tried to keep it looking as stock as i could.. apart from the catch cans obviously.. i even had the NA manifold power ported ( as they flow alot better then trubo manifolds anyways ) and modifed ( all done by alan rajab. his run a 9 sec passw ith his olf red calais with similar manifold set up).

quick run down on the car..

most of this stuff is brand spanking new..

2 speed glide with B&M shifter owes me arm and leg...

3500 TCE stall..

GT40 700hp garret roller bearing turbo , K&N filter etc etc

Motec computer

Nizpro cooler ( painted black and mounted high. cant see uit at all. not even when you open the bonnet )

head was fully reco;d porting. used the nizpro cam. ive got teh specs at home some where il hunt em down later.

two Bosch Motorsport 984 pumps into a surge tank ( very neat set up in the boot )

bosch injectors

full rebuild bottom end. ballacned blue printed, o'ring block etc etc

REBUILT LSD

custom tail shaft

im at work at the moment so thats all i can remember haha much more tho..

lots spent...

its a greenish colour with a slight silver pearl threw it. was re sprayed about 2 years ago .. just b4 i baught the shell. ive got a scracth on the front right bumper but i can get that sprayed no biggy there..

it wil come with all my gauges i have .. monsta tacho. boost. oil pressure. water..

this thing was serviced every 300ks i recon hahaha

but yeh anyways i thought i would chuck it up on here b4 i spamed it anywhere else. dont wanna cause to much interest in it just yet :-)

Ohh and i have bigger breaks siting in my garage for it as well to help it slow down .. it also has koni adjustables ..

im asking $16,500 ono i guess

il try get some pics up this week end when i get some time.

PM me with any further questions....

Edited by VLS_BACK
Link to comment
https://www.sau.com.au/forums/topic/84206-my-vl-berlina-turbo/
Share on other sites

Nah since i got the Gt40 doesnt dropp coolers nik..

im taking her out again with c16 and full race tune.. last time i ran it it was only on a mild 260rwk tune ( on rajabs dyno) nothing major.. not to bad for 1st gear tho. got a 1.4 60 foot launch on it...

but yeh i wanna take it out again so people stop saying ohhh 11.6 i can do that in a stockie VL.

HI Josip, the shells fine on it. just doesnt have nice wheels on it.. purposly. i dont like to attract attention esp cause i live in altona.

Yeh reason why its that price is because if i had it for 18K i dont have the times to prove it.. plus its getting to the stage where every one is getting a 700 roller.. injectors and motec these days. i know rajab has a 5k package. turbo. plenium and motec i think it is..

how fun are these cars to drive tho.. :-)

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...