Jump to content
SAU Community

Recommended Posts

Just thought id give an upcoming Dyno/Open day a plug.

Maroun and Matt (HITman) have just got settled in the new premises and are putting on a Dyno Day to give people a chance to come out and compete, or to just check out the new shop.

Should be a good day and would be great to see everyone out there!

dynoday4.jpg

Here's a couple of maps showing where the shop is located.

Workshop_Map2.gif

Workshop_Map1.gif

Edited by race_solutions
  • Replies 95
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images




  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...