Jump to content
SAU Community

Recommended Posts

Hey guys

Myself and a mate have started up a Melbourne based car club called Vic Street Scene.

The Forums have only been up a couple of days now, it is not based on any make or model so feel free to sign up today

We are just trying to sort out some finer details and then there will be a Cruise organised within the next couple of weeks

www.vicstreetscene.com

Cheers

Steve

Edited by crossover
Link to comment
https://www.sau.com.au/forums/topic/87744-victorian-car-club/
Share on other sites

In case you haven't noticed, we already have one that is CAMS affiliated with over 100 members. Plus our cruises (for members only) are covered by CAMS insurance.

Club meetings are 3rd Tues each month ( tuesday next week) at the Bells Hotel South Melbourne.

Yes myself and my mate who have stated this club are both in the eastern suburbs and there are a couple of members that are from the northern and western suburbs.

I'm sure that there was a time on these forums where there were only a handful of members and there was somewhere out there having a go at you.

It all comes down each to there own...

So You can check it out here or continue to bag me...

Cheers

Steve

www.vicstreetscene.com

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...