Jump to content
SAU Community

Recommended Posts

Here is a 1996 Series 2 R33 Gtst with Manual Gearbox with roll over damage.

Will sale the whole car with all running gear with a complete body shape for repair or I can sale all the car as part (Wrecking)

Car with new compliance plate which complied on FEB 2005

Colour:Black

Interest call 0411660897

No photo avaliable on web unless call me and give me your e-mail address directly!!

oops double post

free bump for advertising providing you dont sell my rio to anyone else :D

Edited by Slide

Looking for

clutch master cylinder

slave cylinder

clutch pedal set (every bolt/part from master cylinder back into the cabin)

handbrake lever + assembly (not the cable though, just the incabin assembly)

Give me a price on these parts, as i want them ASAP :)

PM please

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
×
×
  • Create New...