Jump to content
SAU Community

Recommended Posts

if its shaky den it's wheel balance..

I had the exact same problem, took it in for a wheel balance (obvious solution)

When they jacked it up at the shop i had a look and the dick before me had put spacers in (to push the rims out), which was the cause of my tyre hitting the wheel guard at every little bump, but when i took the spacer off i noticed there was no hub locater. The lack of a hub locater meant that the rim had play between it and the hub. Machined up two of these little bad boys and problem fixed =no shake

This will only be a prob (i think) if you have aftermarket rims and if the guy that had the car before you was a dick, or the dodgey dealer you bought your car from was also a dick (had these problems)

Cheers

Or it could be as simple as a wheel balance -- easier fix too

Link to comment
https://www.sau.com.au/forums/topic/91458-shaky-at-100km/#findComment-1667531
Share on other sites

Wheel alignment will fix how the car travels down the road. If you take your hands off the wheel and the car continues to track straight then the wheels are aligned.

If there are vibrations, then it is probably (with exceptions like mentioned above) going to be wheels out of balance. Most balancing centres can only balance 16-17" rims. I tried to have some 18"s balance and had to have them driven across town to find a big enough balancer. Without casting dispersions upon the guys that did the balance, they may have taken a short cut with your balance if they didn't have the right equipment.

Link to comment
https://www.sau.com.au/forums/topic/91458-shaky-at-100km/#findComment-1671760
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
×
×
  • Create New...