Jump to content
SAU Community

Recommended Posts

To be honest it looks like a angry car. straight up. no holds barred sports car. I guess it could be close to a v6 by the look of the size of the way the engine bay is and nissans attempt for the engine to be above the wheels or behind as much as possible.

Speaking of bodykits though.. I wonder what Veilside is planning if this is going to be the shape.

one thing though is I hope it will be close to the price range of the 350z. There is no point putting it in the price range of a NSX in oz or anywhere else then you will never get buyers.

heres some nice big images / wallpapers of the GTR ;)

http://www.dieselstation.com/archive/Nissa...ept/index.shtml

wrong car :) thats the original prototype... the released one is slightly different :)

  • 2 weeks later...

It's a great looking car...front end I'm not too sure about but I am sure it will grow on me.

Unfortunately I dont think it will be in the same price range of a 350Z. Judging from the article on carsguide I would say it will definitely be in the 6 figure range, especially when the R32 was 6 figures when it was released here. :(

Definitely better start saving :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The downside of this is when you try to track the car, as soon as you hit ABS you get introduced to a unbled system. I want to avoid this. I do not want to bleed/flush/jack up the car twice just to bleed the f**kin car.
    • But again, the engineers said your cast aluminium would be fine based on the load that would be stretching that section. Same load stretching the bolts in a flex (not the twist), with a much smaller cross sectional area than the original part you've broken. It's why you'd need to be using higher strength bolts, but that's just making up for the strength you lose with less area...
    • I am truly amazed someone on this planet was able to cycle the pump using a scan tool. I've always ghetto cycled them on Nissan 90s shit boxes by slamming the brakes and pulling the handbrake to agitate the rear wheels enough to cause a speed difference
    • I didn't actually try it at the time but a Launch X431 with the appropriate software licenses/upsell will have the ABS bleed function. The Consult II you can still find some old sets of equipment but they're really, really expensive:   
    • Well I'll start by saying I'm not an engineer. I am going to go with the KiwiCNC ones.  They are made of 7050 alloy have good fillets and radius.  The material alone is in the order of double the strength and fatigue resistance - Those bolts, once torqued correctly place most of the load at the flat face of the mating surface - the 'stretch' you're talking about through torqueing them up would be far more than the extra stretch 'load' placed on them from a steering input or bump. (in my opinion) so I doubt they would flinch.    - but again "not an engineer".      oh and I don't think stitch welding 7050 is a good idea, likely just weaken the material (from what I read)
×
×
  • Create New...