Resistor Pack

[rb20inside]

i'm putting gtr injectors into my rb20.

i am aware that i need a resistor pack and was wondering if i could use one from a gtr. it seems logical but i thort i'd ask.

[mr_rbman]

pm cubes, he's just done it and used a resistor pack from a r30 skyline i think but don't quote me!

[N I B]

Depends on the injectors you use,if they have the same resistace as the stockers then you dont need anything.

[carl h]

i made my own resistor pack off of good resistors off ebay.

just source out some 10ohm 10w resistors and go from there, not too terribly hard.

[anyjapspares]

ive been told u can just bridge the wiring and it negates the need for the resitor pack

[N I B]

It depends on what ECU you have.

[Cubes]

I've done a lot of looking in to this..

I wouldn't be using 10ohm resistors, they will make the injectors laggy and you will be required to adjust the injectors lag time as a result.

The GTR resistor pack measures up anywhere from 5.5ohms to 5.8ohms. I've checked out the R30 resistor pack and the ones I have came across measure up as 6ohms.

At worse, half an ohm is going to make bugger all difference.

Best part is they are CHEAP and the plug it uses can be bought from any local auto shop for $3.95, meaning you don't have to solder to connect it to the loom, then use the other half of the plug (female side) to make a loop back type plug should you put high imp. resistors back in at a later date.