dopey

R32 rb20 Kkr430 Walbro fuel pump Hdi intercooler 3inch turbo back Apexi safc Adjustable cam gears 12psi Stock ecu

Nice looking car, u have done a good job with it.

That's beautiful, love the colour

Maroon r33 with the plates Tzu222

Yeah I went from a auto it heaps better now haha. How do you find the cushion button on the street.

Nice to see someone else that likes the doze i had mine doing it for nearly two years and never had a issue. Don't know why you had issues with the gearbox cross member the standard r33 manual one bolted straight up and was exactly the same as my auto one.

If it is not to late i am up for it, just need to know how far in advance payment is needed as i just busted my motor so have spent current saving.

Forgot to mention the condenser, fan and something else i cant remember the name of but if you get onto a jap wreckers and just ask for all the engine bay components for the ac, you should get everything you need.

It is up behind the dash but you should have two pipes with thread on them on the firewall beside the exhaust manifold if you still have it.

Do you know wether or not you have the evaporater ? If so you just need the engine bay pipes and compressor.

Nice 4door, that boot lip gives it a nice touch.

Depending on dates and finances, ill be up for it.

After watching your last build I am keen to see what you do with this.

When i noticed mine doing it i figured the larger exhaust would allow more air in it and once the standard cast manifold and dump pipe get hot just ignite any left over fuel.

For the motor loom if you unplug the ecu and two plugs up behind the dash more, that end should feed through behind the front passenger quater panel into engine bay, and the gearbox ones go to some plug just behind where the battery sits. Hope this helps

Looking forward to watching this build, I have a bit of a soft spot for 31s. If you remove the air on you don't need the condeser as long as the heater hoses are hooked up, the heater will still work. With the loom a auto sparky should be able to replace all plugs if not you should be able to just get a new loom.

Mate that sucks, i hope they work out. It is reasons like these i pretty much stopped buying used. Looking forward to seeing more.

White r33 at Gympie Macdonald's, say sticker on drivers side

the only way to do it properly would be to remove or at least loosen all the pipe bolts from the bottom of the manifold, trust me the time it will take to do that is nothing compared to keeping it all solid.

You can use the auto ecu and loom and also cut down the brake pedal instead of a new one, and when you get the gear for it make sure the clutch bracket is not cracked.

While you are at it, put a new clutch, throw out bearing, spigot bush and rear main. You probly already were going to just thought I would say it.

I personally for the tail shaft would just get a custom one made,

Uni mig a good welder and you can get them as a mig,tig,arc. Mine is a 210amp one but can get them smaller

Looks nice and clean, the wide guards realy add to it.

where about are you located,