kosmo90

Cant answer your question unfortunately mate but i can tell u to drop the last half a litre of oil into your motor Overfill it? I thought ppl only did that for track use?

Yeah, cmon wheres the pics? Hope it all went well

Sorry off topic but that is an awsome idea swapping the intercooler pipes like that.

Just bought a 42mm radiator from them, everything fit without any problems no leaks. Edit: r33

Do you have a website/pics/info/pricing? Ecu talk sounds similar, but they don't come up very often. Registering interest.

It doesn't say if the order comes with anything else so I ordered the permaseal full gasket set for the upcoming highflow purchase. After reading a few posts on the subject, I thought it might be worthwhile replacing them. If they don't need replacing then spares will always be handy to have. Thanks for the help guys, M8 1.25 it is. I'll try and get varying lengths and the 10mm head is a great tip Jez.

Hey guys,could anybody tell me the size of the dump pipe bolts? I've just ordered a jjr 3" bell mouth (rb25) and searching has proved fruitless for me, unless im typing in the wrong phrases. I'm not at home for another 2weeks and would like to have everything waiting for me when i get home. Cheers guys P.s Great thread,lots of info

Yeah mate it is. 2 pin plug?

No I plugged it back in at the end of my street with the engine still running, not sure if that's the correct procedure but It came good straight away.

Are you sure the series 1 ecu has limp home mode?? Yeah, i have an s1 and it goes into limp with the afm disconnected (forgot to reconnect once)

Just bought an 8-bit z32ecu off ebay for $100 (it is on the nistune list) $308 to send the ecu to nistune to have the type 2 daughterboard attached an r33 base map installed. $350-450 for the tune (according to mods) stage 1 mods so far. Hopefully that'll be all until i save up for injectors,turbo etc....

I used 700c silicone from supercheap, rtv i think. Does the job while i save up.

There's a restrictor in my outlet line, should I put that in the new catch can setup or leave it out?

Yeah i have a 94 series one with both drivers and passenger airbags, id love to find the history of the car

how about doing the earthing mod to the solenoid and putting a switch in the car? Sorry just reread the first post, scratch that idea.

Hey mate do you still have the CAPP53- ALLOY INTAKE PIPE available? Cant seem to find it on your website,only the silicone ones. Cheers

ROFL

I just bought a 94 series 1 with airbag on the wheel

All done,i took it for a razz to empty some fuel out. I could see the hanger,it was only a single prong and it would only go on the upper loop on the sender unit. Also i had to slide it on from left to right,ah well it must be a series 1 thing. Thanks DJSimmo for your help,i now have a working fuel gauge. Better go fuel up now

Hi,just bought an R33 and tried this as the fuel gauge stays full. (great tutorial) Found the tank had about 3/4 in but i had a feel around anyway,both the pump and the sender were loose. Sender was floating around and pump was down the bottom. Would've been on it's side but for the fuel hose. Managed to locate the fuel pump bracket but i couldn't find anywhere for the sender unit to hang on (going by feel) Does anybody have anymore info on where the sender hanger? is located,i'm guessing that it's to the right of the pump on the back wall? I was looking for two prongs to slide the unit onto (just a guess) Thanks