Jump to content
SAU Community

Recommended Posts

Plan on taking our extensively enhanced GTR R34 to Tassie for a short trip. As there is no 98 octane fuel available there it has been suggested to lower my boost to say .8 bar ( currently it is configured through an Apexi AVC-R boost controller at 1.2 bar) and use a good octane booster with premium fuel (95 octane) which is available over there.

Any one had any experience or comments re the suggestion ? I'm presuming these octane boosters work.

Of course being a retiree the beast probably won't even get to its boost parameters (chuckle). What am I saying! I lie.

post-25792-1136464128.jpgpost-25792-1136464009.jpg

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/
Share on other sites

octane boost is good, only use it if you have to... e.g. when your using 95 or when ur gonna race someone :D

i've used it before and yes i feel the extra boost not much but it works magic :) cheers hope that helps

also the come in different brand but the all work the same u wont notice the difference in brand unless u put it on a dyno and you wouldn't wanna waste ur time seeing which one is better they all do the job. :)

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1839782
Share on other sites

Be careful using octane booster! I, personally will never use it again!

Recently I had to use octane booster due to the lack of 98 ron fuel. Not long after using it my car developed a 'miss' during idling and acceleration.

After taking the car to my mechanic, the spark plugs were removed and had to be replaced. As soon as my mechanic saw the condition of the spark plugs he knew that I had been using octane booster and hadn't told him.

Rarely do I drive the car hard as I value my licence and my car too much! Not sure how common this kind of thing is, but just thought I would let you know of my experience with octane booster and why I will never use it again!

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840016
Share on other sites

I'm pretty sure octane booster only adds 1/10th of a RON...so you can go from 95 to 95.1 if you add a bottle....not good enough.....

Also AFAIK there is only 95 octane at one place in Hobart and that won't get you around the whole state.

At targa we run 98 octane, nothing special, but we have to get it trucked around the state it drums.

I reckon the best thing to do is turn the boost as low as you can, and retard the timing a few degrees, I'm sure Ali can give you a hand.

Maybe post up in the Tassie section and see how thsoe guys are doing it? Its a great place for a driving holiday, enjoy!

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840031
Share on other sites

It says on that pretty spec sheet that it's running a Powerplay-tuned ECU.

Best bet is to call Alistair and ask him what fuel he tuned it to... Hopefully he tuned it on 95 for safety, but if he tuned it to 98, just turn the boost down a bit like you planned, and she should be fine. If you're REALLY worried, get the timing retarded a bit.

Forget those octane boosters. They don't work and just foul your plugs.

edit: Damn you Dundan, stop copying me :D

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840283
Share on other sites

Hmm.. wasn't aware of the fact that tasmania is so removed from the rest of australia and doesn't have 98RON.. was thinking about doing a road tour down there..

What do all the Tassie people do for fuel?

I'd check what they say in their little forum area. Good luck - let us know..

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840296
Share on other sites

After taking the car to my mechanic, the spark plugs were removed and had to be replaced. As soon as my mechanic saw the condition of the spark plugs he knew that I had been using octane booster and hadn't told him.

maybe you need to run hotter plugs.

octane boost will give a brown layer of crap over your spark plug tip. it will eventually need to be replaced but it wont immediately effect a decent set of spark plugs.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1842011
Share on other sites

As Duncan said above, octane boosters only raise the octane level of fuel one or two tenths of a point (0.1 to 0.2) at best. They are a waste of money and would be better sending the $20 or $30 on regular fuel instead, whilst running less boost and not loading the engine too much. Retarding the timing is the best insurance against detonation.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1842501
Share on other sites

what a lovely looking car. not bad for an old retiree. much better choice than a tinny and a caravan. hehe. very nice taste indeed!

duncan, andrew and nxtime have the right idea. octance booster can cause more trouble than it's worth. start with a full to the brim tank (of 98ron) before you hop on the ferry then try and fill up when you still have half a tank left. that should effectively give you a full tank of 96.5 octane (plus you have been able to use half a tank of 98 in the meantime). do the same again at half tank and you get a tank of near enough to 96 octane. after that, you are down to pretty much straight 95. which should be fine on your low boost setting. just keep a little eye on your MFD for anything abnormal, and have fun.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1847794
Share on other sites

maybe you need to run hotter plugs.

octane boost will give a brown layer of crap over your spark plug tip. it will eventually need to be replaced but it wont immediately effect a decent set of spark plugs.

I had NGK spark plugs in it, almost certain they were NGK iridium spark plugs, aren't they supposed to be good?! Are there better plugs?

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1849704
Share on other sites

Guest Mashrock
eh? Tassie has the best driving roads in Aus.

And I'm sure that with standard boost and a few degrees timing retarded you will still be able to get to the speed limit ok......

they have speed limits in tasmania?

p.s. say hi to uncle chop chop for me

Edited by Mashrock
Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1850647
Share on other sites

From the BP web site..............

2. How can I boost my octane?

The octane of a fuel can be boosted by adding proportions of a higher octane fuel. Also available is toluene, which can be used as an octane booster in both unleaded and leaded fuels. Generally each 5% addition of toluene will increase the fuel's octane rating by one number. It is not recommended to add more than 30% of toluene to the fuel. Because of the dangers with incorrect mixing, individual motorist are advised against mixing additives with fuels without first consulting their car engine manual or their fuel supplier.

So check with the Tassie guys where you can get toluene.

:P cheers :D

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1853026
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day  
    • While I was waiting for the new parts to come in for the charge pipe and radiator I decided to do some turbo modification. The drive pressure (exhaust backpressure) was a lot higher that I thought it should be. For 32lbs of boost drive was 55lbs. The turbine housing is a 1.10AR and my turbo builder has suggested to go to a 1.25AR. To test if a larger AR would do anything to reduce drive pressure AND not spend any money I decided to hog out the divider in my current housing. I removed it from the inlet and the whole way through the housing.  After reassembly and testing it doesn't look like this modification did anything for reducing drive pressure or requiring more fuel (making more power). Oh well, it was worth a shot. We'll get some data at the track if it makes it past the 60ft. I also machined a $7 shift knob off Amazon to fit my Stillway shifter since I didn't like the Stillway shift knob. Next on the list was the radiator replacement and fabrication of a new intercooler tube that had no silicon coupler. No pictures of this - I was short on time each night after work to get this done and didn't stop to take pictures.  Next was to get the clutch disks out and replaced. Previously when installing the dogbox I had ordered a set of the same sintered iron disks I had been running because I switched to the 26-spline input shaft. I thought it was odd that they didn't have any markings or brand name on them like all my old disks had but installed them anyway. At the track I could not get the clutch to lock up using my normal strategies. After two track nights I reached out to the clutch manufacturer and ask their thoughts. They said they had to switch the material out because they were having trouble getting the original material and that this new material would not take to being slipped very well.  So out with the first set of 26-spline disks and in with the correct material 26-spline disks. While I had the trans out I added an inspection/service hole. I've wanted one of these for a while. Now I can have a look at things and change the front cover shimming when needed (clutch wear). I hustled and got the clutch change done in a few hours on a Saturday. Hopped in the car and drove home. On the way home I did a 1-3 pull. When shifting from 2nd to 3rd the core plug in the back of the cylinder head popped out and dumped all the coolant. Thankfully I was only 30 seconds from home and coasted it there. Datalog showed nothing unusual and 2.5psi of coolant pressure. That plug has been in there since 1992 but I guess it worked its way out. Pulled the trans AGAIN and replaced the plug, JB welded it in, and made a brace. Also deleted the head drain I had added in during the bearing issue fiasco.  I am currently changing my boost control plumbing to make it cleaner. After that is done I'll make another attempt at getting past the 60.
    • Are you 100% sure this isn't tune related?
    • 140-150 across the board. At this point hoping the grounding harness fixes it. My grounds are all tied to the chassis and none to the battery. For SR and KA that’s never been a problem for me but had a few other guys here and Reddit who told me RB really like a very solid ground setup tied to the battery so going to try that next, I’m stumped if that doesn’t do it. Never had a car have spark and fuel and not fire off before. Only thing I can think is the spark is intermittent/weak because of grounds nothing else really makes sense at this point 
    • I am having close to the same issue. Can you help me with what wire you grounded to get your pump to trigger?
×
×
  • Create New...