Jump to content
SAU Community

Recommended Posts

Hi guys! Man, long time no see for all u guys. I been gone for quite a while. Good to be back tho B)

My R33 has finally reached the age of 100,000 kms now and so its time for a major service. I know there is a thread about this major service and I read it, but I was hoping for VICTORIAN experiences with this major service.

- What was done (other than timing belt)?

- Who did u go with?

- What was the cost?

- Any other problems that needed addressing during or after?

Any posts appreciated. Thanks all!!

BTW, this is the list of tasks that the 100,000km service thread mentioned (I'm scared of the bill!!):

New Iridium Spark Plugs.

Water Pump.

Thermostat

Cam belt

Drive belts.

Oil Filter

Fuel Filter

Check cam and crank seals for leaks usually OK and extra if seals required

Check cam belt pullies

All electricals, exhaust, suspension. Coolant and hoses.

Gear oil 75w- 90 or auto trans service.

Engine, gearbox and power steering get Uniglide treatment.

Clutch and brake fluid flushed and bleed.

Radiator and engine flush.

Clean and treat battery terminals.

Clean terminals to injector plugs, ignition coils.

Compression test.

Spray lubricant on throttle linkages and other.

Adjust water sprayers and additive used

Lubricate door hinges and strikers, bonnet latch, boot hinges, aerial mast.

Check and tighten sub frame and suspension and cross member bolts etc.

Tyre pressures checked and corrected.

Air filter replaced or if performance filters cleaned and re oiled.

Check list for our technicians and report given.

Link to comment
https://www.sau.com.au/forums/topic/103994-100000km-major-service-suggestions/
Share on other sites

ice performance

timing belt and 100k service

all fuilds, plugs, check brakes, check suspension

brake pads/rotors were fine + bushes to be done at 140 ish

most performance places that i can think of wont touch

Water Pump.

Thermostat

Cam belt

Drive belts.

Clean and treat battery terminals.

Clean terminals to injector plugs, ignition coils.

Adjust water sprayers and additive used

Lubricate door hinges and strikers, bonnet latch, boot hinges, aerial mast.

Tyre pressures checked and corrected.

Air filter replaced or if performance filters cleaned and re oiled.

Check list for our technicians and report given.

the rest should be ok however

there some people who insist on replacing the water pump at 100,000

i dont see a pressing need for it, i mean why do that and not the oil pump? they are both as equally as important. unless im missing something?

the 100,000 service will cost around $600 mark ish

and the timing belt change will cost around $450 byitself

so $1200 is ballpark providing they find no major problems

the rest should be ok however

there some people who insist on replacing the water pump at 100,000

i dont see a pressing need for it, i mean why do that and not the oil pump? they are both as equally as important. unless im missing something?

do your water pump!!! i didn't do it for my 100,000k service only to find 6,000 later that it was shagged...

paul, the water pump circulates corrosive liquid so the seals tend to die at about 100k oil pumps don't corrode parts like coolant does...

ice performance

timing belt and 100k service

all fuilds, plugs, check brakes, check suspension

brake pads/rotors were fine + bushes to be done at 140 ish

most performance places that i can think of wont touch

Water Pump.

Thermostat

Cam belt

Drive belts.

i dunno about that... Gerald (ICE) regularly comes home after doing a 100k service and he changes the water pumps without a doubt.

Other stuff, if you asked, im sure they can attend to.

Just remember, some stuff can be done yourself, like cleaning battery terminals and things like that. So you save labour hours by doing it yourself.

yeah sorry i should have said its minaly due to added labour costs

i mean i would prefer they did check my engine and crap instead of looking for sqeaky door seals and so on. paying a price for a performance workshop, may as well have them look at the performance stuff instead of imho oem car stuff which any mechanic place can do.

was unaware of water pump changes at 100,000

mine wasn't done that i know of

yeah u can have everything done but its just gonna crank up the price by stacks

Adz, how long is your car going to be out of action in the garage for? Did G give u an estimate? And also a quote on the cost? or is it a 'well, we'll see when we get there' type of thing (like usual)

Okies, water pump it is. Any suggestion on spark plugs??

hey king, u could always do most of them yourself and save a fortune, things like fluids,filters sparkies r easy but timing belt is a bit tricky

my dads friend is a good mechanic + he is very cheap for us so he did my timing belt and i told him to might as well do the water pump seeing as the belt was off

instead of paying $1000+ i payed like $400 doing most of the shit myself

Adz, how long is your car going to be out of action in the garage for? Did G give u an estimate? And also a quote on the cost? or is it a 'well, we'll see when we get there' type of thing (like usual)

he is doing it himself :D

youve got rocks in your head if you dont do the idler bearings......infact if i had to sacrifice....id sacrifice the water pump for the idlers....if the idlers let go your head has to come off.........if the water pump fails you leak water and the gauge goes up and you stop driving.......but id be doing both

yep, gotta do those idlers too if not already done

I think they are every 80,000 (or 70,000) arent they?

I had one let go many years ago. $1500 later as it smashed all 24 valves to bits, then the motor ate those yummt bits, and so the story went

hey king, u could always do most of them yourself and save a fortune, things like fluids,filters sparkies r easy but timing belt is a bit tricky

my dads friend is a good mechanic + he is very cheap for us so he did my timing belt and i told him to might as well do the water pump seeing as the belt was off

instead of paying $1000+ i payed like $400 doing most of the shit myself

wow...i would like to know where i could get the following parts for $400...

timing belt,both tensioners,plugs,cam seals,crank seal,waterpump,thermostat,tesioner stud,fuel filter,oil filter,engine oil,coolant,gearbox oil,diff oil,3 drive belts and the o2 sensor....any heads up?

Doin mine this Sat mate, will let you know how I go :)

I'm doing all seals, all belts including cam, water pump (becuase it's east to get to when doign the cam belt), O2 sensor (why not while I'm at it), all fluids, plugs etc...

Fun job wasn't it :O

-Patrick

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi GTSBoy, Excuse my ignorance but what does a "Bad" Knee point mean ? 
    • HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
×
×
  • Create New...