Jump to content
SAU Community

Recommended Posts

What do you fellas with Turbo Timers do when you're at a petrol station, refilling?

ie, with the turbo timer on, and the car running......

Im not that comfortable with the idea, and switched mine off. I would have thought it'd be very dangerous to be filling up your petrol tank with the car still running.

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-1997726
Share on other sites

Turbo timers = waste of oxygen (ie; rice)

Turbo timers = good place for a thief to get access to your ignition system

Turbo timers = nothing for your gearbox, diff or brakes

Throw it in the bin and cool the whole car down properly.

:D cheers :laugh:

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-1997732
Share on other sites

Good points (dont know about the 'rice' factor tho - each to their own!)

Plus add-in the fact they are illegal in SA (unless your vehicle weighs over 5T I think).

Mine was disconnected after the first week - I was embarrassed to fill up with the car still running (weird & dangerous), and couldnt stand listening to my car run for 5mins after Id gotten home, changed, had a bourbon & smoke, and then sat down to watch the news (with the damn car still running!@)

:D

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-1997750
Share on other sites

i have an old hks 1 that came in my car that ya can turn off or use pre-set times(30secs, 1 min, 3 mins or 5 mins)...i dont use it! if i have been boosting i will just drive my car around slow and softly for a lil bit or sit in it and let it idol for a lil bit then turn it off.

hey any1 kno where bout in SA(adelaide) i can get it taken out? im from victor harbor and i dont think there is any1 that can do it down here. and i havwnt heard of anywhere where i can get it taken out...oh that is for my "exemption from compliance"

cheers

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-1998098
Share on other sites

My turbo timers built into the alarm (autowatch) so i can remotely turn it off. I rarely use the turbo timer though, switching off at the same time as the car. Its good as there are no controls for anyone to touch or wiring to follow directly. Not too sure how good autowatch are though. Its set a minimum of 90 secs, but probably only let it run that much after ive done long drives.

cheers

Evil

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-2001124
Share on other sites

If the turbo isn't on boost then it's not much hotter if at all than if it was just idling. In fact my motorcycle starts to heat up when stationary/idling, and cools down again at low rev cruising, so if you are driving home off boost, start your "turbo time" from the last time you put your foot down and it'll probably cool down quicker than going from foot-to-floor straight to idling in your garage. And like SK says, think of the extra bits of your car that need cooling off like brakes.

I have the added benefit of having to manually lift my garage door. I leave it idling while doing this so by the time I've parked the car it's done plenty of cooling down and I then just switch the engine off. The car came with a timer but I never use it. If I knew where it was I'd remove it.

Edited by JimX
Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-2001212
Share on other sites

Good points (dont know about the 'rice' factor tho - each to their own!)

It provides marginal (at best) performance or reliability benefits, which you acknowledged by crediting SK's points, while providing a security weakness. However, it does give you another flashing light in the cabin.

How is it not rice?

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-2003565
Share on other sites

dude.. if u have a TT and u fill up... u park, WAIT for it to turn off.. then pop the cap and fill up.. dont be fkn stupid.

also, if u are filling up for petrol, its probably cause your LOW, so u shouldnt drive on boost anyway. (towards the petrol station) so if ur TT goes on, should only be for 20-30 seconds.

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-2012426
Share on other sites

The majority of turbos are water cooled so there is no reason to idle down after a normal drive. If they are designed correctly, even with the engine off, water can still syphon through the turbo for a few more minutes after shutdown.

Its the older school oil cooled turbos with the crap oils they had back then that were a problem. A good synthetic with a oil cooled turbo is usually good enough not to warrant a turbo timer anyway.

Link to comment
https://www.sau.com.au/forums/topic/108341-turbo-timers/#findComment-2012536
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The oil pressure sensor for logging, does it happen to be the one that was slowly breaking out of the oil block? If it is,I would be ignoring your logs. You had a leak at the sensor which would mean it can't read accurately. It's a small hole at the sensor, and you had a small hole just before it, meaning you could have lost significant pressure reading.   As for brakes, if it's just fluid getting old, you won't necessarily end up with air sitting in the line. Bleed a shit tonne of fluid through so you effectively replace it and go again. Oh and, pay close attention to the pressure gauge while on track!
    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
×
×
  • Create New...