Jump to content
SAU Community

Recommended Posts

Wrecking R33 GTST series 1.

* RB25DET..damaged sump, crank pulley, turbo has small hole, cam sensor, timing cover, a/c & power steering pumps PRICE DROP $700

* Passenger side door complete with trim and glass ****SOLD****

* Brake master cylinder $50

* Series 1 computer $200

* glove box $50

* Centre console with lid slight bend at front $20

* Centre vents $50

* Rear tailights black in colour *****SOLD*****

* Rear bar has some damage $150 black in colour price drop $50.. *****SOLD*****

* Front calipers with pads complete $200 *****SOLD****

* Rear calipers with pads complete $200 ****SOLD****

* Rear hubs with handbrake cables $150 ****SOLD***

* Rear bootlid with GTR wing no lock in boot $300

* Front seats $150 each

*Rear seat $100 complete

* Cluster with 76,000k's..broken tabs where screws go $70****SOLD***

* GTR style rear bar with pods to suit $300 *****SOLD*****

* Interior trims from $10

* Front disc rotors ******SOLD*****

* Rear disc rotors $50 pair*****SOLD*****

* Diff $200

* Tailshaft $100

* Rear hicas unit $100

* Power steering rack $100

* Engine crossmember $100

* Front hubs $100 pair

* rear windscreen with hole for wiper ****SOLD*****

* rear 1/4 windows $100 each

* door handles $25each

* Aerial unit $50 *****SOLD*****

* roof lining $50

Plus more..please PM for details or photos etc.

Located in sutherland shire.

Thanks....

Edited by sav
Link to comment
https://www.sau.com.au/forums/topic/117817-wrecking-r33-gtst/
Share on other sites

  • Replies 90
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

ok try answer everyone questions.

* Sorry dont have a/c condensor

* i may sell wing without boot if wing comes off easy enough..i will have a look tomorro night.

* as for the brakes had a lot of interest in them so $600 as apackage..still good just checking the pads but i have 2 sets of rotors so will sell with the best ones.

* Sorry sooley this is the same one as before gearbox sold already

* the tailshaft snapped at the yoke but looks ok still..has the shaft then uni and broke after that $40.

i Mate,

Assuming the front brake rotors fit GTST series 2 I'd be interested.

Could you send close up photos of rotor condition

Cheers

David

0414-232497

[email protected]

Edited by stealth
hey dont no if still available but interested in both rear hubs without discs and without calipers just the hubs are they available.

also is the power steering pump available

i have power steering pump though pulley i damaged $50

hubs sold sorry

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...