Jump to content
SAU Community

Recommended Posts

Full morning? I reckon we'll still be going at this one till the wee hours of the afternoon :)

Also i may or may not head out, hope this helps ;)

depends when you start and if you have all the right tools, morning should see the turbo etc all removed ready for the replacement. afternoon is for new parts.

  • 2 weeks later...

Dont have my skyline at the moment its taking an extended holiday down Batemans Bay :starwars: (lucky girl!) Ill be out in the Silvia though will swing past hopefully 8:30-9.

Hopefully it doesnt rain.

  • 2 weeks later...

I'll be out tonight, depending on what time my mate's 20th finishes. No idea on when though, so more than likely it will bite me in the ass and I won't get out until like midnight.

There’s a nice spot to meet up in the Melbourne CBD. I had a small cruise meet up in the conner of Exhibtion st, and Victoria st, In front of the mantra on the park hotel, tourism Malaysia and Dreamlife wedding photography, around 10+spots. But if members are more than 15+ there is a parking cross the st from the 7-11 on Mazkenzie st, shit load of empty spots on the weekend.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...