Jump to content
SAU Community

Recommended Posts

well last night i went to leave for work and got about 20 metres down the road and couldn't see out my rear view mirror from all the WHITE smoke so naturally i quickly pulled a u-turn and put the car in the garage and took the girlie's car to work as i was running late as it was!

Now i'd just put a new catch can on that i'd made and i just presume i didn't vent it properly (was trying to make it legal) which caused this mess!

Now this morning i put my old catch can back on which is vented with a filter and a few small 1/8 holes! I took it for a drive and it was still smoking but not quite as bad! I'm hoping this is just oil that was still in the exhaust etc burning off??? i pulled back into the garage and there was oily smoke coming from the engine bay (mainly around the turbo, can see slight oil marks/stains where the dump pipe meets the exhaust housing) and exhaust!

Basically have i stuffed something (can't see how?) or do i just need to vent my new catch can and wait for the oil to get out the system? I was reading somewhere that its illegal to have a 'venting' catch can but if you don't vent it properly does this problem i'm having happen or have i made it or hooked it up wrong?

Cheers in advance!

Link to comment
https://www.sau.com.au/forums/topic/127654-urgent-help-please/
Share on other sites

Have done this a few times as well and it seems to clear up fairly quickly and I dont think it will be damaged. :(

Probably idle it off in the driveway as some mongrel will see the smoke if your on the road and dob you in to EPA.

Your breather should by rights vent back into the airbox intake.

I had the same problem, the catch can has a breather in the system... should work ok, are you still getting oil smoke? You may of damaged the oil seal on the turbo? Go have a look at your intercooler, you should find oil deposits in there! Clean it out with metho/kero (ie drain it n empty until it runs clean, DONT tip the cooler upside down as the oil will run through it lol) and clean the pipes out then go for a hard drive to burn any oil sitting in the zorst and have another look to see if that helps, personally im still abit stuck with it all but im tryin the cooler cleaning next week.

I had the same problem, the catch can has a breather in the system... should work ok, are you still getting oil smoke? You may of damaged the oil seal on the turbo? Go have a look at your intercooler, you should find oil deposits in there! Clean it out with metho/kero (ie drain it n empty until it runs clean, DONT tip the cooler upside down as the oil will run through it lol) and clean the pipes out then go for a hard drive to burn any oil sitting in the zorst and have another look to see if that helps, personally im still abit stuck with it all but im tryin the cooler cleaning next week.

i hope its not the turbo cause i've been through that with my old turbo and my new 35/40 is only 2000kms old so it better not be that!, i'm 99% certain its the catch can because it only happened when i installed the new catch can!

The catch can needs to vent to atmo or somewhere...crankcase pressure will build up and bad breath will come out somewhere else. Std breather goes back into intake pipe so instead just put a little filter off a hose tail on your catch can somewhere and let it breath off that.

The catch can needs to vent to atmo or somewhere...crankcase pressure will build up and bad breath will come out somewhere else. Std breather goes back into intake pipe so instead just put a little filter off a hose tail on your catch can somewhere and let it breath off that.

this is what i thought but i heard that venting into the atmosphere is illegal with catch cans? I have my old catch can back on (the one in the pic which vents via a filter!) It seems to be fine, just getting all the oil out the system now is the pain staking part. Mind you it is still blowing a bit of smoke but nowhere near as much!

Edited by mr_rbman

just took it for a quick hard drive and it only smokes a tiny bit driving normally but when it hits boost the smoke is much worse! To me that sounds like the turbo but considering its new and i changed the catch can and all this happened i'm still lenaing towards the catch can being the source of the problem???????????????????

just took the cooler off and there's a bit of oil in that which is probably causing the white smoke when the engine hits boost! Currently cleaning it now and will hopefully get it back on tonight fingers crossed!

Latest ZOOM has a great little article regarding crank case pressure and the ins and outs of oil catch cans and oil breather cans.

There was also a thread here recently where someone had a similar issue after putting on a new can and using wrong size hoses.

I think that thread started off saying “hi flow turbo blown” or something (because of the white smoke)

Even after fixing, there was a bit of smoke as the extra pressure had pushed oil past the turbo seals and so forth and was burning in the exhaust for a bit.

Hope that is all you have done and that nothing is broke.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I drive the Tiguan much harder than the Skyline in all conditions, because it just grips and hooks, unlike the R33 shit box
    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
×
×
  • Create New...