Jump to content
SAU Community

Recommended Posts

Finally got my compliance plate and registration yesterday.

Been driving non stop since then and the car hasnt let me down. ...Everthing I had hoped for.

Used the Maguires products today and shes come up a treat.

First used soft gel wash

then paint cleaner

then water finish polish

..and will wax it tomorrow

is this the right way to do it? Maguires have got so many products that seem to do similar things.

Was hoping to see some of you tonight so I could have a run. Drove everywhere and couldnt find anyone willing to have a bit of fun.

Be seeing ya

says the one in the very shiny clean polished R33

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/
Share on other sites

am certainly loving it.

Car is a stocker but good things come to those who wait. Im a bit worried about my license though. Its such a smooth and quiet (stock exhaust) car that u dont even realise hoe fast your going. I only have 3 point left and crossing my fingers.

Will post some pics soon (after I wax it)

There IS a question in my first post!

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-241750
Share on other sites

No way that is completely wrong the way you have washed it! you haven't given meguirs enough money that way you need to buy the following and place on in the folowing way

1. shampoo that is a nice yellow colour that gets rid of air of the paint

2. a different class 2 type that gets rid of any left over air from the paint incase you didn't get it off from the 1st wash

3 class 3 air off paint remover

4 car shampoo & wash

5 car shampoo and wash cleaner

6. car shampoo and wash cleaner cleaner

OK honestly i think meguirs is a VERY good product but i really think they have gone over board in there range and are hopping for people like us who car dearly about our cars to buy everyone of their products this i think is all that you need!

1. First used soft gel wash

(2. deep cut polish or swirl remover if your car needs it)

3. finish with Gold class wax/polish

these are the only 3 products i have been using for the past 1. 5 years and works a treat... anything else really is overdoing it. Even my friend who details porsches told me the same!

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-242144
Share on other sites

My car sometimes after starting seems to idle eratically for a few seconds before idling normally.

Does anyone know what might cause this?

ALso how many ks do you guys get out of a full tank when driving at a medium to hard level?. Probab only been getting about 250-300 myself

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-243818
Share on other sites

I dont drive my car hard 100% of the time on average I get 450-500km's out of a tank. I generally change gears at 3000rpm around 90% of the time, whilst 7% is around 5000rpm and the rest around 6500rpm. If you only got 350km's out of a 60l tank, I'd suggest you have been floggin it far too hard, back off or you will do some damage, especially if the car was complianced with cheap oil also are you using BP ultimate98?. I get the same rev problem when starting the car, happens maybe once a fortnight... dunno what it is, could be something to do with the AFM.

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-243900
Share on other sites

Originally posted by rob77

I dont drive my car hard 100% of the time on average I get 450-500km's out of a tank. I generally change gears at 3000rpm around 90% of the time, whilst 7% is around 5000rpm and the rest around 6500rpm. If you only got 350km's out of a 60l tank, I'd suggest you have been floggin it far too hard, back off or you will do some damage, especially if the car was complianced with cheap oil also are you using BP ultimate98?. I get the same rev problem when starting the car, happens maybe once a fortnight... dunno what it is, could be something to do with the AFM.

whats the point in having a turbo if your going to be changing gears at 3000RPM.

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-244503
Share on other sites

ImPrOvIsE, if i drive, and shift at mostly 3000rpm - 4500rpm i'd probably get around 400km out of a tank, depends if you're driving on boost a lot too, be a lot different if you accelerate softly up to 5000rpm without generating much boost, than planting it from low revs to 5k. I have taken it easy for a whole tank before and managed 480km (city driving) and the fuel light had only just come on (sits on E for ages before the fuel light comes on).

paul 6000rpm all the time? how often you change your oil and oil filter?

chris.

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-244518
Share on other sites

Originally posted by ImPrOvIsE

whats the point in having a turbo if your going to be changing gears at 3000RPM.

The point is I like to get good milage and prolong the life of my engine and most of my driving is done going to and from work at peak times. The point of having the turbo is that when its late at night and I want to fang it I can. If you wish to drive like a ****nut and change gears *all* the time around 6000+ rpm go for it. Just dont whinge about your poor mileage. I'll ask my questions again, do you use BP Ultimate 98 and what engine oil was put into the car?

Link to comment
https://www.sau.com.au/forums/topic/12887-bout-bloody-time/#findComment-244840
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
    • No, code 21 is very straightforward. It can only be the things described in that diagnostic flow. In fact it has no way of knowing that the spark plug resistance is out of spec.
×
×
  • Create New...