Jump to content
SAU Community

Recommended Posts

can't answer your question but.......

both put together i'd still choose the one in your sig anyday, everyday. :)

yeah thats a very special "Skyfrine" :yes:

haha those 4 red cooking stoves at the back mean = very f**king fast in either way :D

See the stoves... beware!! hah

So you cant drive it on the road?

Pretty sure I read in HPI that it's not registered but it could be if they wanted it too. They would only have to raise the ride height a bit. The car still has climate control and all that shit so it could compete in the super stock class thing at Tskuba.

I'm not sure. Anyone know if its street registered? Either way I'm very sure the Mine's R34 Demo Car sets the benchmark when it comes to R34s on the track (Fatest tsukuba time of 57.7?). The Z tune is a few seconds off but I dont remember the figures of the top of my head.

Z is around 300 K right? Mines is half that correct me if Im wrong...

Think the Mine's is about 200k in Japan, and the Z-Tune was 170k US

But yeah, after speaking to Matt, who drove the Z-tune from Sydney to Melbourne, he said it was pretty comfortable, and absorbed bumps etc really well. I doubt the Mine's would be so forgiving.

The Suzuki Mightyboy wins hands down. The Daewoo Matiz just can't keep up with it's blend of style, practicality and sheer horsepower.

What were we talking about again?

Edited by Big Rizza

Well I've seen the Z tune in the flesh, actually touched it, and it's something to behold. Seeing it fly around Oran Park was something else.

Very impressive car.

I can't comment on the Mines car cause I've only seen it in DVD's. But damn it's impressive in those dvd's.

I think I'd take a Mines R34 GTR though. Just cause.. :ninja:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...