Jump to content
SAU Community

Recommended Posts

  • Replies 6k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Yeh nice, I saw that Z Tune 34 in the flesh when i went with my mate to Sandown 500 to race! it was in the pits parked near the Porsches! yes is quite the vehicle!

Prob try and sell up in a month or two, Just gotta fix up the cracks in the front bar, and a general clean and tidy up as well as a service and a tune!

Well good luck with selling your car hope you get a good price for it :no:

Yeah R34 Ztune is so nice got to see it fly around the track was nice to see such a phat car in the flesh sounds so cool!!!

mine shows page 199?

Thats cause you only have 20 post to a page I have 40 post to a page its in My controls

Well good luck with selling your car hope you get a good price for it :no:

Yeh cheers! what i roughly want for it is about what they go for with the mods it has, BUT in saying that, you never get what you "really" want!

wow work has gone so quick now, 5 min and i'm outa here! Wooooooo Hoooooo.......... Until tomorrow, damit! :)

Edited by Deluxe
Yeh cheers! what i roughly want for it is about what they go for with the mods it has, BUT in saying that, you never get what you "really" want!

wow work has gone so quick now, 5 min and i'm outa here! Wooooooo Hoooooo.......... Until tomorrow, damit! :D

Are you serious its only 3pm sif get to leave then :no::):D

Yeh but us men, only need a shower, slight do of the hair(sum of us) and away we go!

Women on the other hand.................. :sleep::)

Yeah I know it suxs to be a girl :kiss:

I used to work like 3 - 11 for about 6 months straight

now i work 8:30 - 5

Thats not bad but you do heaps of travels aswell thats got to sux!!! :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...