Jump to content
SAU Community

Recommended Posts

Rb20 5-Speed w/ Tail Shaft Good Nick W/ Low Km Exedy Cushion Button Clutch - $800ono

Rb25 Coil Packs - Full Set $100

Rb25 Crank Angle Sensor - $75

Mint Rb25 Turbo W/Stock Dump (no shaft play) - appears to have fresh steel rear wheel SOLD!!!

Rb25 Manual Starter Motor $100

R33 Clutch Pedal $250

R33 and R32 Climate Control Units Got Both $75

R33 Ser II Tail Lights And Garnish $400ono

Cat Back 3" Exhaust Off R33 High Flow Cat and 1 Rear Muffler - No Pics SOLD!!!

R33 M-Spec Front Seats (were in my 32) Clean - $250pr

R32 RH Headlight - $75

R32 Stereo Surround - $50

R32 4 Door Carpet - $50

A31 Nissan Cefiro Rear Bar - Silver - $100

Located In Kedron Nth Brisbane

pm or

0421560017 Robby

Edited by rso84
Link to comment
https://www.sau.com.au/forums/topic/148498-rb2025-parts-r32-and-r33-parts/
Share on other sites

can organise it to be full conversion, box, shifter, clutch, bolt in gear boot on floor, clutch bedal, slave cylnder, tail shaft, gear box mount... only think missing is muaster cylnder n lines... 1200

  • 2 weeks later...
c'mon champ, update me.. you've had money for a week now.. whats the progress?

any sort of reply will do.. you've been online since i posted this, you've been online many times since i pm'd you last.. whats going on? you have my money.. whats happening?

WARNING! dodgy trader..

deposited money into his account for the RB25 crank angle sensor and havnt heard from him since. he ignores private messages and hasnt updated me since payment was made almost 2 weeks ago.

if anyone knows who/where he is, please go knock on his door for me.. cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bah! I can't see the point in custom number plates at all. I went to the rego office, fished through a box of "premium" plates (the ones that had the "not as tall" option for the front plate) and picked the one that had a 32 in it. That's the limit of the effort and cost I will put into number plates. The only plate that I'd consider paying for would be 2332, but that's not possible here because it already exists from probably 90 years ago, and it would cost a fortune to obtain it, if it were available.
    • After chasing my tail with LS results..... and cheaper than a turbo swap... How confident are you that the dyno is accurate relative to other results? How fast is the car - What MPH does it actually run? Is this similar to what people running this power would expect?
    • Hi mate I am having an identical issue with my 98 R34 GTT. The engie suddenly cuts out under load at about 3-4k, black smoke out exhaust. Almost feels like traction control kicking in. No CEL but still going to check codes later today. Car was sitting in the shed for about 5 months before hand and only idled a few times, took her out with about 1/4 tank, filled up and thats when the issues started happening.  Threw on a spare set of coils/harness and checked plugs which was no help. Recently had fuel pump/filter changed so surely thats not the issue unless condensation in fuel, I just havent had the time to drain it It's running a hi flow turbo, bosch 1000cc injectors, walbro 450L, Z32, Nistune etc... All about 2000km old.
    • I always wonder where the obsession with legal/illegal spacing on number plates in the UK comes from. Because it comes up in comments in every UK-based video I see on youtube. From my point of view all of your plates look a bit odd. Just because there are no markings whatsoever. In Australia we have the state that has to be on it. In Europe you get stamps and state logos. Yours look a bit like a throwaway draft that people then stuck with. And attached with blu tack so that it falls off at the slightest disturbance. Not trying to hate, but it's interesting how things are done in different countries. Do you have to follow a lettering convention when choosing a custom plate?
    • Hybrid sounds like a supercharger... It's half a turbo, with a belt to drive it! Oh wait, they're just called super chargers...
×
×
  • Create New...