Jump to content
SAU Community

Recommended Posts

You mentioned same day same dyno so I have no idea how the tuner felt he was able to give your car back in that state.

You have nothing to worry about going back to them.

Plug the stock ecu in and go for a drive with them and then plug in the $1,000 tuned PFC and drive again. If its as bad as you say then you wont need to say a word. Get him to bring his wideband along as that will have a story to tell as well.

And why would he do the base run in third and final tune run in 4th?

Just dont fiddle with any settings and contact them asap, like be there with the car first thing in the morning. If you have to work then call them up first thing to let them know and arrange a time.

If the tunning shop does not replaced there air/fuel sensor regulary it gives a bad feed back, They are only good for a certin amount of work.

Sounds like it is running to rich, they may not have set the AFM correctly but for that price it should be better than sweet!

if payed a $1k for a tune and its as bad as that id punch the tuner in the head. If he had any pride watsoever in his work it wouldnt of ever left the workshop in that state.

Edited by fEkuaR
if payed a $1k for a tune and its as bad as that id punch the tuner in the head. If he had any pride watsoever in his work it wouldnt of ever left the workshop in that state.

Anger management classes not working then.....lol

i found shit loads of power

went through all the map and it looks ok

changed some timing cells drove it today

went ok still shitty idle, but better

installed a boost controller tonite

would not idle or rev and missed

at idle it was reading 3/4 load

took out the o2 sensor tested all good

when putting it back in i noticed the wires

on the car loom side were all exposed

repaired the plug and its a diff car heaps of boost

loads in the right spot now i just have to clean my

plug s :-)

back to the dyno

back off to the tuner today just droped her off

he still thinks there not much he can do hes going to check it again and

give me a read out

probs i found

wiring exposed on o2 sensor

fouled plugs regaped to .8

afm dirty

tps slightly out of range

faulty boost soleniod wouldnt go above 4psi

back off to the tuner today just droped her off

he still thinks there not much he can do hes going to check it again and

give me a read out

probs i found

wiring exposed on o2 sensor

fouled plugs regaped to .8

afm dirty

tps slightly out of range

faulty boost soleniod wouldnt go above 4psi

Oowch... and they couldn't work that out for you for $1k? Don't take it back until your 100% happy and don't give them another cent.. bastards...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...