Jump to content
SAU Community

Recommended Posts

Hey ppl

Just wondering what some of the top track speeds have been achieved in an R32 GTSt are?

Sorry if this is a repost.

I have a GTST and am just wondering.

julz

Edited by R32 GTSt KID
Link to comment
https://www.sau.com.au/forums/topic/157714-top-speed-in-ur-r32-gtst/
Share on other sites

  • Replies 75
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

R32 kid -

As public forum, I think you should edit post to say "on a race track"

Just dont think the mods and admin would like that, and esp the above post saying 180 on public road...not good.

Hey ppl

Just wondering what some of the top speeds that have been achieved in an R32 GTSt are?

Sorry if this is a repost.

I have a GTST and am just wondering.

julz

Depends... with or without VTEC yo?

11ty billion m/s

I think it would be safe to assume 180km/h.

I would like to suscribe to you're newsletter if possible thanks Paul :D

But one question - how did you measure it in billions?

what sort of flux capacitor did you use and who was it tuned by? :P

With the RB20DET and 220 rwkw, 225 kph on turn in to the kink before the chase at Bathurst. It probably sneaks up a bit from there in the short straight, but I was too busy to look.

:P cheers :D

I would like to suscribe to you're newsletter if possible thanks Paul :D

But one question - how did you measure it in billions?

what sort of flux capacitor did you use and who was it tuned by? :P

i used an ultra sensitive lidar which only has increments/readings in .11ty of a billion

my flux capacitor was tuned by kawaii_hachi_roku performance just down the road from PHATR32's track in northern mars

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...