Jump to content
SAU Community

Recommended Posts

hey everyone.

Over the past 2 weeks i have been reading and researching about RX7 FD and i am quite tempted to buy one.

My only drama is that i am a bar tender and dont earn a million dollars a week.

I would love to have it as my daily driver but i am concerned that the cost of keeping it on the road would send me broke.

I have been looking at FD's and the ones that i have found that are for sale in my price range have single turbo conversions and rebuilt engines (3mm seals and the whole lot). They are also series 6's and around the 93 to 94 cars. (would love to buy PAZZO_RX2 RX7 but i doubt he will accept my offer of cash)

I have also been looking at 32GTR's that are fully rebuilt and are monster built from the ground up. Which tend to be awesome and prefect cars. Lots of power and can be daily drivers with ease.

I have around that $27k mark to spend ( i may have alittle more if i can find a FD or GTR that is of the highest quality for me to buy).

I was hoping to get some help and advice on how much a FD would cost me to keep, drive and maintain.

Please consider the following:

Insurance - must have insurance on a FD as they are stunning cars, also GTR are mechanically perfect so also would need it!

Servicing

Rebuilds

Petrol

Everyday maintainance.

And any helpful tips or advice you can offer me would be greatly appreciated.

I am looking to buy a car sometime this week so i am hoping that peopel can get back to me ASAP.

Thankyou and help is greatly appreciated.

Jake

Edited by jakegts
Link to comment
https://www.sau.com.au/forums/topic/159333-looking-to-buy-a-rx7-fd-or-gtr/
Share on other sites

thats actually a tough decision to make mate, i feel your pain. you'll have alot of guys supporting the 32gtr's but they are getting a little old and its quite hard to find one in the condition you're looking for.

bottom line is go have a look at whats available, look in the for sale section in the forum too, have a drive of both and see which fits you better.

although my vote is with the FD.

DO NOT buy a rotor... every one i know has regreted it and end up muttering to themselves how much the thing is costing them in upkeep. That said GTR's arnt cheap to keep either but at least you'll only rebuilt the RB once.

If you want FD advice isnt there a rotor furum you can quiz? im sure they'll know 70 billion times more than skyline owners

That said no car is sexier than an FD, so buy a shell and drop in RB powah!! best of both worlds

I havent owned a fd, but did have a fairly modified fc as a daily

Dont believe the bullshit you hear about them needing a rebuild every 6 months. Mine did 200,000ks before it even needed a rebuild, and it was done only as a precaution. Fuel is a killer with rotaries, they use much more than a skyline. They are a great looking car, easy to get power out of, and much cheaper to rebuild - i bought a block package for around 3k - ported, hurley seals - just needed the bolt ons and it could have easy gone to 500kw. They are a true enthusiasts car, and need to be looked after

Ive had my r33 gtst for 6 months now and again, its not the same but i think its quite a good daily driver, much better than the fc was. Fuel consumption is much less, its very comfortable, roomier and modern inside, also easy to get power out of, but more expensive to rebuild than a rotary.

I reckon test drive both and then you will decide which one is best

they are both amazing cars. FD RX-7s are a truly great japanese sports car. GTR is too. to be honest if you can't spare around $1000 a month to run the car then either one is not a good choice. Far better to look at an S15 Silvia. Still a fast, nice looking car, but much more reasonable to insure, fuel, repair and modify. then buy the FD or GTR (or both!) when you are at a point in life with more $$$.

well im going to get a fd after my 32 gtr.

it really depends if ur gna have the fd modded. im keeping my fun to the 32 gtr, and going to have a fairly stock fd in future. i read on ausrotary forum previously that you can mess with the a/f ratios on a fd really quickly even by just a catback, needs a tune with every powerful mod.

check out ausrotary forums :)

  • 2 weeks later...

i had the exact dilemma it was either a series 7 or a r33 gtr

i was so close on getting the fd but as soon as i test drove the gtr my mind was set.

the gtr just felt beasty, and had alot more room, as in perfromance wise there are both good but i just love the pull of a gtr.

i think you should at least test drive both cars then you would know what you want.

goodluck!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You will now be able to lift the parcel shelf trim enough to get to the shock cover bolts; if you need to full remove the parcel shelf trim for some reason you also remove the escutcheons around the rear seat release and you will have to unplug the high stop light wiring from the boot. Next up is removal of the bracket; 6 nuts and a bolt Good news, you've finally got to the strut top! Remove the dust cover and the 3 shock mount nuts (perhaps leave 1 on lightly for now....) Same on the other side, but easier now you've done it all before
    • OK, so a bunch of trim needs to come off to get to the rear shock top mounts. Once the seat is out of the way, the plastic trim needs to come off. Remove 2 clips at the top then slide the trim towards the centre of the car to clear the lower clip Next you need to be able to lift the parcel shelf, which means you need to remove the mid dark trim around the door, and then the upper light trim above the parcel shelf. The mid trim has a clip in the middle to remove first, then lift the lowest trim off the top of the mid trim (unclips). At the top there is a hidden clip on the inner side to release first by pulling inwards, then the main clip releases by pulling the top towards the front of the car. The door seal comes off with the trim, just put them aside. The the lighter upper trim, this is easy to break to top clips so take it carefully. There is a hidden clip towards the bottom and another in the middle to release first by pulling inwards. Once they are out, there are 3 clips along the rear windscreen side of the panel that are hard to get under. This is what the rear of the panel looks like to assist:
    • Yes. Autos typically work from the speed sensor on the pinion shaft of the diff. I also think that even if you have a proper speed sensor for the bog manual in the manual box, that the signal it outputs is not compatible with the auto dash anyway. You should consult that manual (the book, not the gearbox).
    • And I just realised that that advice is slightly nonsensical for a GTR, because you need 2 of them. But it is otherwise true.
    • Having had a reasonable look at the car, I'll be able to remove the (one time) rams and retract the hinge (they are held in the down location by a tiny (m3?) sacrificial screw) which will get it physically back in shape. From there if you remove the rams you need a resistor to turn off the airbag light (as Mark said, there are plug in kits and I might go that way because its reversible). And...per all the threads on here, even if you have the resistors to turn off the airbag light, the bonnet light will stay on as it writes to the airbag computer history - that is either replace the airbag controller, reprogam the EPROM (if I can work out how), or remove the globe from the dash. Having seen how sensitive this system is, if I had my time over I'd pre-emptively remove the rams, even on a road car, because this is all a very unnecessary pain in the arse. Reminds me, time to go and have a look at the Fuga too....
×
×
  • Create New...